Results 1 to 4 of 4
Thread: 241c transfer weeping
12-10-2008, 07:31 PM #1
241c transfer weeping
I have a 91 Chev Suburban witha 241c trans case that is seeping from the back where the drive shaft comes out. I changed the main seal, no differance. The fluid seems to be coming from the the center where the spline goes into the yolk on the drive shaft. Is there a gasket kit that I can order to fix this?
12-10-2008, 07:52 PM #2
Your talking about the front yoke on the driveshaft. You can pull the shaft out and clean the yoke out and then put some RTV sealant inside the base of the yoke, or buy a new yoke.
12-11-2008, 07:17 PM #3
Well I guess for now the RTV will have to do. Thanks for the help.
12-11-2008, 07:24 PM #4
RTV, JB Weld, Duct Tape and Bondo are some of this worlds best inventions. Oh, I can't forget WD-40.Trevor - Huntington Beach, CA
2007 GMC 2500 4X4
By TXWagon in forum GM PowertrainReplies: 7Last Post: 07-20-2011, 04:01 PM
By desertjoe in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 06-01-2010, 11:05 AM
By firstname.lastname@example.org in forum GM PowertrainReplies: 0Last Post: 04-05-2009, 11:17 AM
By homer911 in forum General ClassifiedsReplies: 0Last Post: 02-16-2009, 10:25 PM
By CustombyCollision in forum GM PowertrainReplies: 1Last Post: 10-19-2007, 07:19 AM
Tags for this Thread