GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default Hard to convert my 4L80E to a manual?

    I was wondering if anyone knows if it is possible and how much it would cost to convert my 4L80E to a manual tranny with overdrive? Or what there is even available? I swapped out my old 350t in my 79 blazer to the rock crusher...complete swap. I know this would be more expensive and harder. Any info would be great!!! Thanks a lot, Joe
    Joe. 1996 Chevy Suburban 2500 with the 454 and the 4L80E.

  2. #2

    Default

    As far as I know, no suburban since probably the mid 80s has ever had a manual transmission as an option in Suburbans. I don't know why, but that's how it is. As such, you will certainly have some pretty major fabrication and body cutting ahead of you. You will have to cut a hole in the floor pan for the floor shifter, fab up a bracket for the clutch pedal and linkage, and if you keep an EFI motor in the suburban, figure out some way to fool the computer into believing the auto tranny's still there and functioning correctly. Quite a steep task, but certainly possible if you're fab knowledgable.
    Christopher

    1991 Chevy Suburban 1/2 ton 2WD w/ chevy SBC 350-3/4 ton drivetrain upgrade w/4.10 gears 200K miles
    2005 Saturn ION-2 Stock 265K miles
    1982 Bronco, 1993 Bronco (sold), 1971 M35A2 Deuce and a Half



    There are 10 kinds of people, those who understand binary, and those who dont...

    Remember kids, the only difference between screwing around and science is writing it down- Adam Savage

  3. #3

    Default

    It'd be more than it's worth. A couple thousand at least.
    The brackets and shifter hole templates are already done for you. Find a 1996 Chevy pickup with a manual, take all the required brakets from it after noting their positions. Make a cardboard cut out of the trans tunnel for your shifter hole.
    Then get the driveshafts, transmission, and ecm and put them in your truck.

Similar Threads

  1. Convert 2wd to 4x4
    By Pats1pab1 in forum GM Powertrain
    Replies: 4
    Last Post: 04-23-2010, 08:56 PM
  2. 2x4 convert to a 4x4
    By tankers1985 in forum General Chevy & GM Tech Questions
    Replies: 2
    Last Post: 09-07-2009, 07:55 PM
  3. 2000 chev 2500 4l80E hard shift codes included
    By beyondhope in forum GM Powertrain
    Replies: 15
    Last Post: 07-01-2009, 08:20 AM
  4. How hard is it to convert an A/C suburban to Non-A/C?
    By gt1009 in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 3
    Last Post: 05-30-2008, 09:48 PM
  5. Convert S-10
    By Steve in forum Chevy S10 Forum (GMC Sonoma)
    Replies: 2
    Last Post: 05-27-2007, 03:10 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •