Results 1 to 2 of 2
Thread: ABS Light Reset
12-30-2008, 07:12 PM #1
ABS Light Reset
I have a newly acquired 95 suburban, with the ABS light on.
I honestly cannot fix at this time (best guess is the pump), but was looking for a way to kill the dash light.
I had read that if you remove the 60A fuse from the circuit block, it disabled ABS and turned off the light.
I have done that and also, pulled the ECM-1 and ECM-B fuses to try to eliminate the light, but the light still remains.
Short of reaching behind the dash and pulling the bulb, what else can I try?
Thanks!burbn' in NC
12-30-2008, 10:05 PM #2
You could get some of that black Gorilla tape and be very neat and tape it up real good so it does not annoy you until you can get it fixed.
Bert:out:"Race Car Spelled Backwards is Racecar"
03 Silverado 2WD extended cab 5.3 with towing package white/silver
By 9191gmc in forum Chevy Truck Tech ForumReplies: 1Last Post: 07-24-2010, 10:17 PM
By hookedup in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 05-31-2010, 10:16 AM
By 9191gmc in forum Chevy Silverado Forum (GMC Sierra)Replies: 6Last Post: 08-18-2009, 08:10 AM
By mashburn in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 07-14-2009, 02:27 AM
By TheChadders in forum Chevy Silverado Forum (GMC Sierra)Replies: 3Last Post: 02-24-2009, 10:20 PM