Welcome to the GMTC - Chevy Truck Forum.
Chevy Truck Forum

GM Truck Club is the premier Chevy Truck Forum & GMC Truck Forum online ~ Since 2004.
Registered Users do not see the above ads. Register Today ~ It's Free and gives access to the whole website.
+ Reply to Thread
Results 1 to 3 of 3
  1. 01-12-2009, 07:48 PM #1
    mainiac1
    mainiac1 is offline
    Jr. Apprentice mainiac1 is a glorious beacon of light
    mainiac1's Avatar
    Join Date
    Jan 2009
    Location
    Florida
    Posts
    11
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default 01 Silverado Posi drive axle gear needed

    Hey again everyone, does anyone out there have an old but serviceable passenger side axle drive gear (spyder gear) (Rear end) to fit an 01-07 Z71, G80, GT4, 3:73 gears. Chevy in their infinate wisdom only sells the carrier parts as a set to the tune of $500.00 for the g80 locking differential. for $425 I can buy an aftermarket carrier from Auburn or Easton which I'm probly gonna have to do if I strike out tonight online. Also, which aftermarket carrier is the best bang for the buck?
    Tanks, Jamie
    Reply With Quote Reply With Quote
  2. 01-13-2009, 01:13 AM #2
    silveradojc
    silveradojc is offline
    Former Member silveradojc is a glorious beacon of light
    silveradojc's Avatar
    Join Date
    Jan 2009
    Location
    motor city area
    Posts
    23
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    You may already know this, but try your local salvage yard. You could probably pick one up rather cheap. Good luck
    Reply With Quote Reply With Quote
  3. 01-17-2009, 09:06 AM #3
    mainiac1
    mainiac1 is offline
    Jr. Apprentice mainiac1 is a glorious beacon of light
    mainiac1's Avatar
    Join Date
    Jan 2009
    Location
    Florida
    Posts
    11
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Rather cheap turned out to be an $800 piece of crap that had already been repaired but not a good repair. long story short I returned it and bought a new Auburn carrier and fixed it Wed night. Lucky for me no shimming reqd and didn't get hot after test run.
    Reply With Quote Reply With Quote

 
« Previous Thread | Next Thread »

Similar Threads

  1. silverado posi/not?
    By Fudgeyoutoo04 in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 4
    Last Post: 06-06-2009, 12:29 PM
  2. 1974 K10 Suburban Rear Axle Help Needed
    By joemud in forum Powertrain
    Replies: 13
    Last Post: 04-13-2009, 12:17 PM
  3. Final drive gear identification
    By CarpenterGuy in forum Powertrain
    Replies: 22
    Last Post: 02-22-2009, 07:37 PM
  4. 08 Silverado 2500 rear axle gear ratio
    By Trident in forum Performance & Fuel
    Replies: 1
    Last Post: 02-26-2008, 11:08 AM
  5. timing gear drive question
    By 89suburban350 in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 6
    Last Post: 04-29-2007, 06:51 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Powered by vBulletin® Version 4.1.7
Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.
Copyright 2004-2011. This site is for entertainment purposes only and is not associated with General Motors.
All times are GMT -5. The time now is 01:07 PM.
vBulletin 4.0 skin by CompleteVB