Results 1 to 3 of 3
01-14-2009, 10:00 PM #1
Anyone had any luck with K&W Block seal? [Expired Topic]
I have a 99 3500 Express cargo van 5.7 that needs a head gasket. I really dont feel like pulling the engine apart right now. Has anyone tried using K & W block seal to seal a head gasket? I hear that this is the best one out there. Thanks.
01-14-2009, 10:15 PM #2
- Join Date
- Jan 2009
i haven't seen to many head gasket problems in these years how was it diagnosed i seen more valves hang up in these than anything as far as a sealant it only work if there's antifreeze leak if it blown between the cylinders your screwed it needs tore down
01-15-2009, 06:35 PM #3
I have coolant in my oil (milky), white smoke when cold, but it never overheated. I did notice some coolant coming from the rear of the engine between the head and block on the drivers side. Many people tell me that its usually the intake that leaks on the 350's. Truck has 169k miles on it. I have been adding anitfreeze for a month now. I have always checked the oil and it appeared fine until the other morning. I immediately pulled the van out of service and put my 05 in service. I started to take the engine apart but decided to try the block seal first. If that does not work, then I will tear it down and do it right.
By kodaniel in forum Chevy Silverado Forum (GMC Sierra)Replies: 1Last Post: 03-05-2010, 10:05 AM
By TrailLeadr in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 01-13-2007, 07:18 PM
By smoore2530 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 03-03-2006, 01:47 PM
By Chris in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 2Last Post: 08-24-2005, 02:15 PM
By TrailLeadr in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 2Last Post: 07-04-2005, 08:16 AM
Tags for this Thread