Results 1 to 10 of 10
Thread: engine sluggish
02-11-2009, 12:07 PM #1
I have a 2000 3/4 ton crew cab with the 5.7 engine. Sometimes the truck will be sluggish when I first start it and take off, it will stumble once or twice then it will run and perform normal for a period of time.It dosent do this all the time, the check engine light dosent come on, the truck has 141k miles on it and is 100% stock. The plugs wires cap rotor were replaced at 100k miles, I've also replaced the fuel pump and filter recently (pump went out). Has anyone else had this problem or know what may be causing this? I am guessing it could be the fuel pressure regulator but havent done any test to confirm this.
02-11-2009, 02:18 PM #2
Have you tried some good ole Sea Foam yet?
02-11-2009, 02:47 PM #3
I have heard great things about seafoam.Dan
1999 GMC Sierra 2500 350 vortec
1967 Jeep M725 ambulance 230 tornado
1990 Cherokee Limited- 3 inch lift on 33's
...and every one of em has issues
If you have any questions or problems don't hesitate to send me or any other GMTC moderators a PM
02-11-2009, 03:09 PM #4
Have they stopped making Sea Foam? I cant find it at Auto Zone anymore.Current Daily Driver:
2003 Chevrolet Silverado 1500 - 4WD - 4.8L V8 - True Dual Exhaust Setup, Cat Delete, Cherry Bomb Glass Packs
02-11-2009, 05:05 PM #5
Im a big believer in sea foam, this is one of the first things that I tried.
02-11-2009, 05:29 PM #6
02-12-2009, 01:52 PM #7
I havent checked the exaust flow at idle but it seems to perform perfect at all other engine speeds including towing and 90% of the time it will not be sluggish when taking off, its a intermintent problem that im afraid that will decide to get worst at a time when its inconvenient for me. Thanks for your suggestion I will check my exaust flow at idle and repost.
02-12-2009, 02:07 PM #8
Might wanna look into the coolant temp sensor. It makes the mixture rich until the engine warms up. If its not working properly it could throw off the air/fuel mix at start up. Some people say the coolant temp sensor is the most important sensor when it comes to gas mileage.
04-05-2010, 07:00 PM #9
- Join Date
- Jan 2008
2000 suburban 1500 5.3l...I had the same problem for a long time.(almost 3 years) Was told by GM dealer it was a fuel pump...Fuel pressure regulator showed none of the normal symptoms. Finally I took a chance and change it ( $45.00-Autozone) and my suburban runs like a new truck now..
04-06-2010, 02:07 PM #10
you need to check your fuel pressure and then fuel trim and see whats going on. If you can get iac counts too that would be good
more than likely your intake is clogged with carbon. dont waste your cash on the junk at the part stores, get an intake/injector clean done the rite way with the rite chemicals (bg is the best ive been around so far)GM TECH
05 silverado shortbed
By Gatorfan71 in forum Performance & FuelReplies: 5Last Post: 07-16-2010, 07:41 PM
By Lil Butch in forum GM PowertrainReplies: 5Last Post: 06-30-2010, 01:27 AM
By Ron Inverso in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 08-26-2009, 07:29 PM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 0Last Post: 06-23-2008, 08:10 PM
By Steve in forum Announcements & FeedbackReplies: 4Last Post: 06-05-2007, 02:53 PM
Tags for this Thread