Results 1 to 9 of 9
Thread: valve adjustment?
02-16-2009, 10:26 PM #1
- Join Date
- Jan 2009
- Ft. Wayne, IN
allright, i have a question about the valve adjustment on my truck...
it is a 92 reg cab long bed with a 355 (.030 over 350)
tore it down to replace the headgaskets and pulled the heads, and intake manifold, while replacing the gaskets i noticed the clip that holds the hydraulic lifter together had come apart.
so i got a new set of lifters and installed them, adjusted the valves per service manual. however i did not prime the engine with oil beforehand. got it back together and fired it up and seems to run like crap...
my question is, since i did not prime the engine, do i need to readjust the valves and see how that does? i'm sure the timing is set, i'm kinda lost on this and need the truck back asap... thanks for reading and replies.92 Silverado 2500 "tow bi***"
355 v-8 2wd dual exhaust
00 Jeep Wrangler "toy"
2inch spring spacers, 1inch body lift on 35's with cut fenders
4.0 inline six, 5 speed
By ahlberg in forum GM PowertrainReplies: 7Last Post: 02-28-2010, 08:57 PM
By gargoyle725 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 4Last Post: 07-29-2009, 07:26 AM
By skipbeau3790 in forum Member IntroductionsReplies: 1Last Post: 11-02-2008, 11:36 AM
By Trex in forum Chevy Colorado Forum (GMC Canyon)Replies: 6Last Post: 05-12-2008, 04:48 PM
By Sabre7 in forum Lifted & Offroad SuspensionReplies: 17Last Post: 03-03-2008, 09:54 AM