GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default Front wheel drive only

    Hi I have a 96 S-10 Blazer and tow it behind a motorhome. I tow it with a car dolly and remove the rear drive shaft. On my last trip I realized I didn't bring the drive shaft with, so I drove around in front wheel drive only. Just wondering if anyone else has done this. It seems to be fine.

    Thank You Fishook

  2. #2

    Default

    welcome to the site, cant say that i would recommend doing that, i have due to broken rear shaft while mudding, but only for a short trip

    2003 Z71 Silverado LS
    Access roll up cover
    Bed Rails
    Billet Grill insert
    Bed Rug
    CB with PA system
    Waiting to be installed
    Two 8in RF HX2 punch( would have 12s but they got stolen)

  3. #3

    Default

    For emergency situations it should be fine but I wouldnt make a habit of doing this.
    Theres a few companies that make driveshaft couplers, with one of these installed you dont have to pull the D/S just un couple it and leave it in place might be a little easier and alleviate forgetting the D/S again.

Similar Threads

  1. converting 2 whel drive to 4 wheel drive
    By jdaugherty3 in forum GM Powertrain
    Replies: 15
    Last Post: 11-24-2013, 07:15 AM
  2. Choosing Front- or Rear-Wheel Drive - Wall Street Journal
    By Steve in forum Chevy Traverse Forum (GMC Acadia, Buick Enclave)
    Replies: 0
    Last Post: 06-16-2010, 03:51 AM
  3. Four Wheel Drive ( when to use it )
    By Alaskan in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 14
    Last Post: 01-08-2010, 11:30 AM
  4. 06 Sierra 4 wheel drive front end noise
    By vjjack04 in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 5
    Last Post: 11-19-2007, 09:57 PM
  5. Front-Wheel-Drive, 2-Mode Hybrid System Debuts in 2008
    By Steve in forum The Coffee Shop ~ Chit Chat
    Replies: 0
    Last Post: 01-21-2007, 03:24 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •