GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2

Thread: corvette servo

  1. #1

    Default corvette servo

    anyone put one of these in the NNBS?
    recieved mine today and it seems so difficult but everyone says its easy

  2. #2

    Default

    not sure if there is a difference but I installed one on my 02 silverado. It wasn't hard at all to install, but I do recommend two people. Also if you have access to a lift (makes it easier)..jack stands should work. You also need a little trans fluid because when you pop it out you will loose maybe a half quart. I believe the hardest part was...there is a spring on the back of the servo that the pin slides through that was kinda aggravating (had to use a mirror to line it up), but most people say it is the slip ring that holds the cover on. It really does only take like 30 min to do. Hope that helps

    Tools required
    Pry bar (to push in the servo to get ring off and put ring on)
    C-Clamp (compress spring to change out part of the servo..once out of truck)
    Mirror (optional) (to line up pin and spring)
    Flathead Screwdriver (helps with the slip ring)
    1 quart trans fluid

    Not sure if yours have it but there is a heat shield that covers the servo in the truck you will have to remove it first

    ALSO USE YOUR TOW/HAUL SWITCH TO MAKE SHIFTS EVEN FIRMER!
    www.myspace.com/teamimageracing
    www.myspace.com/brotherspolish

    2002 Silverado
    5.3L
    Corvette Servo
    Spectre Air Intake
    MSD 8.5mm Super Conductor Wires
    AC Delco Iridium Plugs
    Flowmaster 40 Series
    Alpine Head Unit
    Next Mods
    2" Lowering Shackles
    Loud Mouth Grill
    :gasp:

Similar Threads

  1. Corvette Servo
    By bzboardco in forum GM Powertrain
    Replies: 7
    Last Post: 10-16-2010, 06:53 AM
  2. Replies: 0
    Last Post: 03-26-2010, 01:10 PM
  3. corvette servo?
    By redneckarmyMP in forum GM Powertrain
    Replies: 8
    Last Post: 03-13-2010, 11:30 PM
  4. How about a Corvette?
    By Steve in forum Chevy Corvette Forum
    Replies: 12
    Last Post: 10-26-2009, 03:56 PM
  5. Vette servo
    By heavy chevy in forum Performance & Fuel
    Replies: 1
    Last Post: 03-12-2009, 08:11 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •