Results 1 to 3 of 3
05-09-2009, 10:39 PM #1
Adjusting idle on a 1990 350 TBI motor?
Is there any way to adjust the idle on a 1990 TBI 350? I know the tag under the hood says it set & sealed at the factory, so I really don't know what to think.
Is there a way to adjust this? or should I just leave it alone?Current truck: 1996 Ford 250, 7.3 Powerstroke diesel. Dana 60 SAS, stage 1 160cc injectors, T500 High Pressure Oil Pump, TS 6-position chip, full 4" exhaust, intake, 285 Falken Rocky Mountain AT's, boost/EGT/trans temp pillar gauges, etc...
By twofakind in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 12-10-2009, 01:23 PM
By safetyfast in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 06-06-2009, 06:43 PM
By Crawdaddy in forum GM PowertrainReplies: 6Last Post: 11-17-2008, 02:07 PM
By myolbug in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 10-06-2008, 03:15 AM