GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default compression a little low on 1 cylinder

    did a compression check on the engine and 1 cylinder was a little low. I don't remember the numbers, but it was slightly lower than the other 7. the engine overheated once, real hot! should I be concerned about this? hopefully I'm just loosing a little power and worse gas mileage. Will this lead to a complete engine failure soon? I don't want to be stuck in NorthDakota winters with a dead engine middle of nowhere. that happened to me once in the fall and it wasn't even that cold and we froze our asses off.

  2. #2

    Default

    As long as it was within 10-15 psi, I think it is,you're good....
    Joseph


    Airforce Veteran (7 years)


    NRA Life Member

  3. #3

    Default

    i think the others were 140 and that one is 120. we don't notice any problems, i suspose there is a power loss

Similar Threads

  1. Any easy way to disable Coil for compression testing?
    By klaymonster in forum General Chevy & GM Tech Questions
    Replies: 0
    Last: 07-17-2010, 04:35 PM
  2. 99 Suburban, 5.7, no compression? HELP
    By coloradosuburban in forum General Chevy & GM Tech Questions
    Replies: 6
    Last: 03-07-2010, 06:52 PM
  3. Where's Cylinder #7
    By hblock72 in forum GM Powertrain
    Replies: 1
    Last: 10-23-2009, 01:28 PM
  4. Master Cylinder is it Bad?
    By ceyermann in forum Lifted & Offroad Suspension
    Replies: 4
    Last: 08-13-2007, 06:30 PM
  5. compression numbers
    By Diceman in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 9
    Last: 03-19-2007, 08:32 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •