GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 7 of 7
  1. #1

    Default intermittent stall all speeds and idle [Expired Topic]

    Intermittent stall no rime or reason, at all speeds from idle to 70mph. Will restart sometimes right away, sometimes have to waite up to an hour. Diagnosed as lose of fuel pressure.
    Replaced fuel pump with new delco,checked all wiring, cleaned grounds. Replaced fuel pump relay with new delco, checked all wiring that was accessable, for breaks, corosion , arcing. Disconnected all visable conectors and checked for breaks, corosion, arcing.
    HELP!!! This vehicle is my bread and butter I'm getting hungry.

  2. #2

    Default RE: intermittent stall all speeds and idle

    did you replace the fuel filter?

    Sometimes it's the simplest things.

    Technology is great, when it Works,
    And one Big Pain in the Ass When it Doesn’t.
    Detroit Iron Rules, All the Rest are Just Toys.
    94 GMC Burban, 5.7L (350), 4X4, Auto
    86 GMC Burban, 350, 2 WD, Auto
    79 GMC pickup plow truck, 400, Full time 4X4, Auto
    86 Pontiac Fiero SE, 2.8L, Auto, only mid engine American car
    See a Pattern yet?

    15 year GM assembly line worker.

  3. #3

    Default Re: RE: intermittent stall all speeds and idle

    Quote Originally Posted by 84fiero123
    did you replace the fuel filter?

    Sometimes it's the simplest things.
    Yes. Also replaced the fuel pump sock

  4. #4

    Default RE: Re: RE: intermittent stall all speeds and idle

    Do any codes come up?

    You never said, what year, what engine, what fuel system, who did the first diagnosis?

    All those things make a difference.

    Does it die anytime?

    Or just after it's been running for a while?

    If it's only after it's been running for a while it may be a computer problem, or electrical.

    When a coil goes it can do this. I've had that problem with older trucks, and even cars.

    Next time it dies check the fuel pressure right then if it won't start right away. It's simple if its fuel injection and not throttle body injection. Just push the test nipple on the fuel rail if you don't have a tester. You should get a lot of spray if the pump is primed.

    If you have a tester just screw it on the nipple.

    Like I said before we need to know more about the truck.

    Technology is great, when it Works,
    And one Big Pain in the Ass When it Doesn’t.
    Detroit Iron Rules, All the Rest are Just Toys.
    94 GMC Burban, 5.7L (350), 4X4, Auto
    86 GMC Burban, 350, 2 WD, Auto
    79 GMC pickup plow truck, 400, Full time 4X4, Auto
    86 Pontiac Fiero SE, 2.8L, Auto, only mid engine American car
    See a Pattern yet?

    15 year GM assembly line worker.

  5. #5
    Legend unplugged's Avatar
    Join Date
    Sep 2006
    Location
    High Deserts of SoCal
    Posts
    2,554

    Default Maybe fuel return?

    Most fuel injection systems are closed loop. Meaning that fuel is pumped to the injector rail (when used) or the TBI, and unused fuel is sent back via the return line. Like others have said, you didn't mention the year.

    I had a similar problem that was hard to diagnose. I went to all the trouble to plumb a fuel pressure gauge and mount in outside the vehicle where I could see it through the windshield. Sure enough, when it started crapping out the pressure dropped to 0-4lbs which wasn't enough for the injection system.

    Check the fuel return lines. You should be able to blow air back through and hear air in the fuel tank.

    Might just be a bad O2 sensor.

    Check out this article on closed loop fuel systems. A little on the technical side, but worth the read. Tech to Tech
    There is no way to happiness....happiness is the way.:yipi:
    http://kx6ijq.blu.livefilestore.com/y1pcOFVNH4ix1hjyGUVyXK5LRfef7qSeWzlZDorpQhIEfkZ2ZA  _vXMYypuKMJFw671uF2ZPhjez_j-atRmcjM2zQKpQi1JSsB75/burb1.JPG
    High Desert SoCal
    93 K1500 burb (personal) 350 AT 3" Lift 250K+
    02 Honda Civic LX
    Looking for a 1990's Miata for an engine swap

  6. #6

    Default RE: Maybe fuel return?

    Hi Thanks for the come back. This is a 1999 chevy suburban. The original diagnosis is from the chevy dealership in town. The test was done with a fuel pressure gage attached while driving the vehicle. It stalls hot or cold on the highway or in stop and go traffic. The truck is running a 350 vortec. No codes on the computer.

  7. #7

    Default RE: Maybe fuel return?

    Well that knocks me out, not familiar with the system, sorry.

    I really can't understand why it wouldn't kick codes, but who knows.

    Just read my signature.

    I would say that the new pump is bad, not unheard of.

    Technology is great, when it Works,
    And one Big Pain in the Ass When it Doesn’t.
    Detroit Iron Rules, All the Rest are Just Toys.
    94 GMC Burban, 5.7L (350), 4X4, Auto
    86 GMC Burban, 350, 2 WD, Auto
    79 GMC pickup plow truck, 400, Full time 4X4, Auto
    86 Pontiac Fiero SE, 2.8L, Auto, only mid engine American car
    See a Pattern yet?

    15 year GM assembly line worker.

Similar Threads

  1. engine near stall at idle
    By wtchevy97 in forum General Chevy & GM Tech Questions
    Replies: 5
    Last Post: 04-19-2010, 05:41 PM
  2. intermittent rough idle
    By thattallguy32 in forum GM Powertrain
    Replies: 6
    Last Post: 12-08-2009, 10:29 AM
  3. csfi rough idle and stall
    By tried&true350 in forum Chevy C/K Truck Forum
    Replies: 0
    Last Post: 11-19-2009, 10:38 PM
  4. '03 K2500 6.0L Vortec -- erratic idle/near stall
    By cmjust0 in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 5
    Last Post: 10-13-2008, 12:20 PM
  5. 1995 Sub 2500 no low idle or tans shift [Expired Topic]
    By jlee804 in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 6
    Last Post: 05-29-2006, 03:48 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •