Results 1 to 8 of 8
Thread: Did I do something wrong??
09-18-2009, 03:44 PM #1
Did I do something wrong??
I put new shocks on my '94 Burb. Now it rattles every time I hit a bump. Where there bushings in the old shocks I needed to reuse? If I grab the upper part of the shock, I can twist it just enough to make a clacking sound as it hits the mounting bolt. What's wrong here? Shocks are Monroe Gas Magnum and they didn't include any hardware at all.
Ok, I think I may have it figured out. Seems you need to really crank the mounting bolts hard enough to bend the bracket in on the shock. Then it doesn't rattle. Is this right?
Last edited by blackburb; 09-18-2009 at 04:18 PM.
09-18-2009, 05:29 PM #2
I would think you need to reuse the factory bushings, I wouldnt want to bend something up that is holding something so vital to the vehicle99 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
09-18-2009, 05:51 PM #3
I don't know if there were bushings. I threw the old shocks away.
09-19-2009, 07:40 AM #4
- Join Date
- Aug 2009
tryy making some makeshift bushings out of an old mudflap or something like that and see if that works.
09-19-2009, 09:49 AM #5
You need to tighten the bolt enough to clamp the bracket tight to the tube inside the bushing.When you hear hoofbeats, look for horses not zebras.
09-19-2009, 12:50 PM #6
09-21-2009, 09:57 PM #7
- Join Date
- Sep 2009
Had the same problem. got rit of the mertic bolts. Went with standard bolts . And used washer on inside takes up space. hope this works for you. It did me.
09-21-2009, 09:59 PM #8
Washers inside the bracket are a good idea if you have that much space.
By 1slols1 in forum Performance & FuelReplies: 2Last Post: 11-30-2009, 06:58 PM
By Kady in forum GM PowertrainReplies: 29Last Post: 03-17-2009, 10:09 PM
By mike54 in forum GM PowertrainReplies: 2Last Post: 12-22-2008, 09:41 PM
By billw in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 03-09-2008, 12:31 PM
By 89suburban350 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 05-21-2007, 03:14 PM