Results 1 to 4 of 4
Thread: LH6 vs L76
08-18-2009, 10:37 AM #1
LH6 vs L76
Both engines have the VVT and AFM and both are small blocks. However, one is the 5.3 and the other is the 6.0. So my question is: What exactly is the mechanical difference between these two?
To Be Completed (Eventually):
6" BDS Suspension lift | KingShocks Front and Rear Coil Overs | 4.56 Gears | 35" A/Ts (TBD) | Cervinis 07-12 Silverado Ram Air Hood | Fab Fours Front Winch Bumper (CS07-H2051-1) | Fab Fours Full Size Rear Bumper (CS07-W1850-1) | RX-2 Series Main Grille (Black) | Line-x Bed and wheel wells | Skid Plates | Rizor Automated Tonneau Cover | Custom Bed Insert | RBP RX-3 Series Nerf Bars | Kenwood Excelon DNX9990HD | JL Audio Stealthbox (2x500RMS) | JL Audio HD 1200/1 Class D Mono Amp | JL Audio C5-653 Components (Front) | JL Audio C5-650 Components (Rear) | JL Audio Slash v2 300/4v2 Class A/B Amp
08-18-2009, 05:15 PM #2
my first guess would be bore n stroke same as 5.0 n 5.7
99 tahoe 2 dr. 4x4 7.4 4L80-e NP246, SAS, dana 60 hp, sterling 10.5 rear, gibson headers, and alot of tricks of the trade !!!!!!IF YOU'RE NOT CHEATING YOUR NOT TRYING!!!!!!!!
08-18-2009, 05:49 PM #3
Most "family" motors are just bore and stroke. The 3X00 series is the same, a 3.1, 3.4, and 3.8 are all the same sized block, just different bore and stroke, and in the case of the 3.8 heavier internals being that it easier to make one block a SC then the next one on the line NA, instead of having two seperate lines.99 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
08-18-2009, 06:07 PM #4
the block is different to accommodate the bigger bore
Tags for this Thread