Results 11 to 13 of 13
Thread: Bad vibration from 25-80mph
03-16-2013, 01:39 PM #11
LoL, I just realized what you meant! I see that the original post was 2009 and someone resurrected it. Well, I hope that he got it fixed by now!!!
- - - Updated - - -
Last edited by Pikey; 03-16-2013 at 11:16 PM.
1995 Silverado 4x4
6" BDS Suspension Lift-3" Body Lift-Add A Leaf in rear -Trailmaster SSV Shocks-Duel Steering Stabilizer Kit -AirAid Cold air intake-
4.56 Gears with Detroit Auburn Locker-Pro-Comp Traction Bars with duel shocks-Aluminum Skid Plate Kit-38.5" x 16.5" Mickey Thompson Baja Claws-Constant Dropping fuel gauge
2005 Yukon XL Jet Power Programmer, Bilstein Shocks, Bilstein rear springs, Helwig Anti-sway bars, EGR Window Visors, EGR Hood Shield, Denali Headlights, Headlight harness upgrade, GE NightHawk Bulbs, White Night Rear lighting system http://www.gmtruckclub.com/forum/sho...5-GMC-Yukon-XL
2002 Silverado ext cab 2wd (Sold)
2003 Yukon XL (Totaled)
03-16-2013, 11:09 PM #12Unless the u-joints have never been replaced. Then they are held in with a plastic that requires melting the plastic to get the u-joint out. I would NEVER hammer on a drive shaft or yoke. Either use a press or a C-clamp with the proper sized sockets to push the u-joints in and out. Hammering them is a good way to bend a ear on a yoke or a drive shaft. Which can turn into an expensive mistake.94 Chevrolet K1500 4x4. 5.7L 350, 5-speed (AKA Betty) Or Rust Bucket...depends on if I'm mad at her.
03-17-2013, 12:21 AM #13
- - - Updated - - -
fy 2009 means For Year 2009 .
By Z-71 in forum Chevy Silverado Forum (GMC Sierra)Replies: 17Last Post: 02-10-2012, 06:23 PM
By 88stepside in forum GM PowertrainReplies: 0Last Post: 11-29-2009, 01:44 PM
By CornhuskerChevy in forum Audio, Video & Gadget TechReplies: 2Last Post: 08-09-2009, 10:35 PM
By jdog468 in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 02-26-2009, 11:08 AM
By makthenif in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 0Last Post: 12-19-2007, 08:17 PM