GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 5 of 5
  1. #1

    Default Is this a good guess?

    Ok...heres whats goin on

    My truck has been running funny, and after a whole bunch of guessing I came to the conclusion that i have a fouled plug somewhere, but i never got a chance to check it because ive been working two jobs.

    Well, tonight i went to crank the truck up, and when its cold i always have to double pump the key so i dont ruin the starter...well this time after the first pump of the key, i stopped it, when i went to turn the truck over, all i got was aclicking sound. is it possible that the truck wont turn over because it is stuck on the combustion stroke on that cylinder, and since the plug is fouled, it wont turn over? i am goin check it out tomorow morning but i just want some ideas just in case.
    "We must be the change we wish to see"
    -Ghandi


    -New Project
    1989 GMC C1500 Sierra ST
    5.7L 350 V8
    5 Spd Manual Trans.

  2. #2

    Default

    No
    More than likely you've got a bad electrical connection or a bad battery.
    Or if your really unlucky you lost a timing chain.
    Unless you have extremely high compression it wouldnt stick on the combustion stroke a factory starter has a lot of low end torque. If your compression was that high youd likely be blowing out cylinder head gaskets.

  3. #3

    Default

    So i popped open my hood and went through checking things and my distributor rotates if i twist it. is this normal?

  4. #4

    Default

    Quote Originally Posted by m.gauthier View Post
    So i popped open my hood and went through checking things and my distributor rotates if i twist it. is this normal?
    That would be considered a bad thing.
    Whats rotating the whole outer housing or the button?
    If its the outer housing check the hold down bolt below it, you'll have to set it as close as you can get to the original setting before it got loose and then adjust with a timing light.
    If its the button the first thing to check is the gear on the bottom of the distributer shaft.
    Either way I think you have big problems.

  5. #5

    Default

    Gotta tighten the hold down bolt. Theres my rough idle issue ive been having probably. And my starter is bad. Theres my clicking noise. Thanks for the help

Similar Threads

  1. Guess that tool!
    By Cableguy in forum Games Forum
    Replies: 56
    Last: 08-30-2010, 12:23 PM
  2. It's about time I guess
    By ShelbyTS661 in forum Member Introductions
    Replies: 9
    Last: 05-07-2009, 10:43 PM
  3. well i guess i should say Hi...
    By Akula682 in forum Member Introductions
    Replies: 10
    Last: 11-06-2008, 06:50 AM
  4. Popcorn prices go up. Guess why?
    By Cableguy in forum The Coffee Shop ~ Chit Chat
    Replies: 11
    Last: 07-13-2007, 10:50 AM
  5. I guess I've lived all over the place
    By ChevyFan in forum TX - North Texas Chevy Truck Club
    Replies: 5
    Last: 01-04-2007, 05:18 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •