Chevy Silverado Remote Programming 2007, 2008, 2009, 2010

[Steve]

Silverado Remote Programming Instructions for 2007 (new body style) - 2010

Use this Procedure for Vehicles with Driver Information Center Buttons

This information is in your Owners Manual in the Drivers Information Center Section.

1. Insert your Key and turn to ON position so that the Driver Information Center display appears.
2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays in the DIC.
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays in the DIC.
4. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximatley 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step 3.
   
   
   This vehicle can have a maximum of eight remotes programmed.
   
   
6. To exit programming mode turn key off and remove key.
7. Test remote(s).

Use this Procedure for Vehicles without Drivers Information Center Buttons

1. To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)
2. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
3. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display
4. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
5. To program additional remotes at this time repeat step 3.
   This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove key.
7. Test remote(s).

Chevy Parts
Chevy Remote

[TMRuiz]

Will this reprogramming of the remotes work if your original remotes didn't have remote start but the new remotes do have it. Will this make the remote start feature work?

[Vincennes02261897]

BUMP. Anyone know about TMRuiz's question? I'm also curious.

[shadetree]

I have a 2011 Chevy Silverado with the Driver Information Center. I have punched every button and cannot find the display "RELEARN REMOTE KEY". If I could find this the rest should be easy to program a 3rd remote to keep as an extra. Does anyone know what I am doing wrong to not find this. Thanks