Results 1 to 5 of 5
10-29-2009, 10:51 AM #1
Turn Signal problem.. doesn't pulse..
First off its a 92 sonoma reg cab short box 2.8L and well my left turn signal is messed up now. At first I thought it was just because the bulb was burnt out so I replaced that. Didn't cure it, checked the fuse, looks to be intact and fine. So now I got no no clue. The indicator has been slightly (broken) since I picked up the truck last year, meaning it won't self cancelle and just stays on even after I've completed my left turn. But now the bliner just lights up and stays on, it doesn't blink.. Any input guys?2010 Sierra Nevada Edition
4.8L Ext. cab - Black Z85 4x4 G80
Shaved a couple badges and 4x4 stickers, DeeZee Red label Low Pro gloss black Brite plate cross box,DeeZee gloss black Brite plate bed rail caps , K&N,more to come.
10-29-2009, 11:00 AM #2
pull the bulbs out of the taillight and check the actual socket, if it is brown or black inside it is fried.99 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
10-29-2009, 11:07 AM #3
the socket looked fine when I changed it, the bulb lights up, but it just doesn't flash for signaling.
10-29-2009, 11:22 AM #4
Swap the bulbs just to double that its not another bad bulb.
10-29-2009, 12:20 PM #5
sounds like your switch may be badGM TECH
05 silverado shortbed
By bigbing64 in forum GM Electrical TechReplies: 0Last Post: 06-02-2010, 03:03 PM
By SPCMarty in forum Chevy C/K Truck ForumReplies: 0Last Post: 01-17-2010, 07:15 PM
By minivan25 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 09-09-2009, 01:58 AM
By ycats in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 8Last Post: 08-24-2009, 02:33 AM
By Stick in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 06-22-2009, 08:21 PM