Results 1 to 2 of 2
Thread: too much negative camber ?
10-29-2009, 07:07 PM #1
too much negative camber ?
i have a stock suspensioned 1990 chevy k-1500 4x4 with factory wheels and 265-75-16 tires.
about 6 months ago i had the pitman arm, idler arm, and sway bar links replaced, and they supposedly set the front alignment at that time. i was told i did not need tie rod ends or anything else. this is a trust worthy shop i have dealth with for a few years now. he could have told me i needed more, and i would have gone with it, but they said that is all i needed.
before and after the alignment the tops of the front tires are noticeably pointing outward more than the bottom. this is neagative camber, correct ?
the outside tread on my tires are wearing more than any other area on the front tires. is this a sign of a bad amilgment and the negative camber ?
should i get it realigned ? it has been about 6k miles since i last rotated the tires.
i want to get it right before i buy new tires.
10-30-2009, 03:02 PM #2
have the alignment checked sounds like a issue
2003 Z71 Silverado LS
Access roll up cover
Billet Grill insert
CB with PA system
Waiting to be installed
Two 8in RF HX2 punch( would have 12s but they got stolen)
By livetoridemoto119 in forum Lifted & Offroad SuspensionReplies: 1Last Post: 01-23-2010, 09:29 PM
By mike1193 in forum Chevy C/K Truck ForumReplies: 3Last Post: 12-07-2009, 04:33 PM
By Chevy Newby in forum Lifted & Offroad SuspensionReplies: 8Last Post: 02-27-2009, 08:55 PM
By ProjectJimmy in forum Lifted & Offroad SuspensionReplies: 5Last Post: 02-23-2009, 04:30 PM
By scottkh in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 07-16-2008, 10:13 AM
Tags for this Thread