GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default Installing Side Steps

    O.K. ordered some side steps or nerf bars or whatever you want to call em and tried removing the body bolts under the truck where the mounting brackets attach to and no luck getting them off! That's with just a regular ratchet wrench. I'm thinking you need an impact wrench to remove them ****ers! Anyone go through something similar?
    2009 Silverado LT Black
    5.3L Flex Fuel and Active Fuel Mgmt.
    Z71

  2. #2

    Default

    I did have to use a long ratchet and a piece of tubing slipped over the end for extra leverage, but they came out fine, although they're very long.
    Be sure, when installing your mounting brackets, that they don't touch the bolt pockets when you get it all tightened down or you'll end up with body creak like I experienced. I had to go back and insert a couple of thick washers between the center bracket and the body to get enough room so it didn't touch. And be sure to torque the bolts evenly; my instructions said to 75 lbs/ft.
    After a couple of days, go back and torque ALL THE BOLTS again after everything settles in.
    Merry CHRISTmas!
    The Cheap-*ss Modder & Thread Killer
    The Realist says, "The glass is too big".

    2013 GMC Sierra 1500 SLT Z60 4WD Crew Cab
    Mineral Green Metallic w/ Tan Leather Interior
    5.3 L FLEX w/AFM, 6A, Cheap-*ss Mods
    32 Dump Club Member
    Range V8 AFM Eliminator

  3. #3
    Legend
    TRPLXL2's Avatar
    Join Date
    Jan 2009
    Location
    Norwalk, Ohio
    Posts
    3,368
    Blog Entries
    8

    Default

    You shouldn't have to use an impact on those bolts, I have never had a problem with mine. But there's always that chance that your truck was built on a friday, and whoever put the cab mounts on at the factory forgot to put NEVER-SEEZ on them.
    2004 Chevy Colorado
    LS1 5.7 swap/TBSS rear axle swap

Similar Threads

  1. Painting side steps
    By Chaser1 in forum Chevy Truck Accessories
    Replies: 5
    Last: 04-14-2010, 10:24 PM
  2. Side steps paint process
    By Chaser1 in forum General Chevy & GM Tech Questions
    Replies: 0
    Last: 04-12-2010, 05:12 PM
  3. side steps.
    By bbwalker665 in forum Chevy Truck Accessories
    Replies: 4
    Last: 11-26-2009, 11:37 AM
  4. Side Steps/nerf Bars
    By MRFASTPHIL in forum Chevy Truck Accessories
    Replies: 7
    Last: 11-10-2009, 06:48 AM
  5. Side Steps.
    By ChevyTech in forum Chevy Truck Accessories
    Replies: 3
    Last: 07-25-2007, 09:36 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •