Results 1 to 3 of 3
Thread: transfer case issues
12-30-2009, 05:14 PM #1
transfer case issues
I'm new to this site so hopefully I'm posting this correctly.
I could really use some advice on my 1995 Chevy 1500 with 220,000 miles, it has a 305 motor and is 4wd. I'm not sure what transfer case or transmission it has.
The other day during a snow storm i engaged the 4 wd drive and drove quite a while in 4wd. During this driving the truck almost stalled coming from a dead stop, and will not shift into 4wd while driving (I need to be parked). I checked the transfer case level thinking maybe it was low, just find out that it was overfilled by about 1 1/2 quarts, and the transmission was 1 1/2 quarts low.
Is it possible to for the transmission fluid to some how leak into the transfer case? If so what is the name of the seal in between the two that would cause the problem?
Any help is appreciated.
12-30-2009, 09:19 PM #2
Ya the input shaft seal will let the trans. fill the tcase those tcase aren't to hard to tear down
99 tahoe 2 dr. 4x4 7.4 4L80-e NP246, SAS, dana 60 hp, sterling 10.5 rear, gibson headers, and alot of tricks of the trade !!!!!!IF YOU'RE NOT CHEATING YOUR NOT TRYING!!!!!!!!
12-31-2009, 05:57 PM #3
Great! Thanks for the helpBrian
1995 Chevy truck
223,000 miles and counting
:fighting0098: chaos, panic and destruction...my work here is done
GM ALL THE WAY BACK
2007 Chevy Imp
2006 Chevy Colbolt
By tpkamp in forum Chevy Silverado Forum (GMC Sierra)Replies: 4Last Post: 06-26-2010, 12:09 PM
By mrcheek in forum GM PowertrainReplies: 5Last Post: 04-06-2009, 11:26 AM
By email@example.com in forum GM PowertrainReplies: 0Last Post: 04-05-2009, 12:17 PM
By mrcheek in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 03-27-2009, 04:02 PM
By DRafalske in forum GM PowertrainReplies: 2Last Post: 01-12-2009, 09:31 AM