Results 1 to 10 of 15
Thread: Blower Motor Resistor 1996
12-28-2010, 05:39 AM #11
- Join Date
- Sep 2010
- Near Kankakee, Illinois
At this point in time you might also want to think about what overloaded the resistor.
If the blower hasn't been changed this would be a good time to change it. Also wash out the AC coil and heater core while your there.
The wiring feeding the blower motor is a little on the light duty side.
Add a ground from the blower to the dash pivot bolt while you're at it.
There is a plug there feeding the blower motor. The wires here frequently have the coating heat damaged & unless it has been replaced they will eventually fail.
I use a 1/4" Craftsman cordless ratchet for a lot of the hard to reach spots.
The other tool I use is a little ratchet that accepts 1/4" hex bits. I got it out of the bargain bin at Napa for $4. I know that stuffs made in China but I've never seen those anywhere else.
I believe the screw heads are 7 or 8mm.
Last edited by jrsavoie; 12-28-2010 at 05:44 AM.1994 Chevy 6.5 turbo diesel K3500 4x4 long bed, crew cab, 5 speed 235,000 miles
1995 Chevy Tahoe 6.5 turbo diesel 4x4
1995 Chevy 6.5 turbo diesel C2500 2 wheel drive, long bed, extended cab
1996 Chevy K1500 Suburban 6.5 turbo diesel 4x4 245,000 miles
1998 Chevy K2500 Suburban 6.5 turbo diesel 4x4 235,000 miles
!991 International box truck, 4700 low pro, Spicer 6 speed, DTA 360, 18' box with side door. 500,000 miles, for sale $3000
By TheShamrock7 in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 14Last Post: 09-08-2010, 01:02 PM
By Bob Urban in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 01-10-2010, 10:01 AM
By Red Rado in forum Audio, Video & Gadget TechReplies: 4Last Post: 10-22-2009, 04:44 PM
By 74 scamp in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 02-21-2009, 01:02 PM
By tomis24 in forum Member IntroductionsReplies: 1Last Post: 12-20-2008, 09:17 AM