GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3

Hybrid View

  1. #1

    Default 85' no voltage to choke

    I have a 1985 C10 - 5.0 the choke and the throttle position switch do not have any voltage to them. Check the fuse block and the fuses are OK. Any suggestions?

  2. #2

    Default

    I don't have much experience with the older models, but I thought the choke and throttle was all mechanical? It looks like I'm wrong but I thought they didn't switch to that until '87...

    But anyway since it's your truck and I probably don't know what I'm talking about, I would start by checking the grounds. That's the easiest and cheapest way.
    Current truck: 1996 Ford 250, 7.3 Powerstroke diesel. Dana 60 SAS, stage 1 160cc injectors, T500 High Pressure Oil Pump, TS 6-position chip, full 4" exhaust, intake, 285 Falken Rocky Mountain AT's, boost/EGT/trans temp pillar gauges, etc...



  3. #3

    Default

    I tried tracing back as far as I could see where the wire ends up.
    I'm not sure if they are in part of the ECM or not.

Similar Threads

  1. low voltage please help
    By circaglobe1 in forum GM Electrical Tech
    Replies: 1
    Last: 08-20-2010, 12:39 AM
  2. 1984 C-10 choke question
    By oletrkguy in forum Performance & Fuel
    Replies: 3
    Last: 04-29-2010, 09:10 AM
  3. converting choke to manual choke????
    By socal77k5 in forum GM Powertrain
    Replies: 7
    Last: 04-14-2010, 08:13 PM
  4. keep losing voltage
    By tnchevy in forum General Chevy & GM Tech Questions
    Replies: 16
    Last: 06-30-2009, 07:13 PM
  5. Woman attacks boy, attempts to choke him, police report - Florida Times-Union
    By ChevyFan in forum Chevy Avalanche Forum (Escalade EXT)
    Replies: 0
    Last: 01-30-2008, 08:30 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •