Results 1 to 5 of 5
Thread: Door lock
02-12-2010, 05:55 PM #1
I am about to pull out my .50 cal Desert Eagle and put my driver's side door out of its misery.
The door closes, but the inside handle sticks out, so the door will not latch. Push the handle in and the door will latch. Obviously it is a matter of a spring on the latch has somehow become dislodged, not allowing the handle to spring back
I am trying to get the lock out as I have a relacement. Each time I take the three screws out of the lock it drops. That's OK, but it does not drop down far enough to see how to remove the rods or how to get at them (I have the inside panel off.)
I removed the vent but can't see far enough upwards to see anything.
I decided to give up and try it another day but now when I close the door it will not latch as it appears another spring has broken or come loose. The locking arm just swings back and forth.
The Haynes manual was very helpful. "Take the three screws out and remove lock."
I could have written a better description with my eyes closed.
TonyYesterday has been defined. Tomorrow is yet to come.
02-12-2010, 11:33 PM #2
Hello there fellow Canadian and welcome. What year is your truck? A little more info is required.Ken Beida
2010 GMC Sierra Crew Cab 4X4, 5.3L
2009 GMC Sierra Denali, 6.2L = 403hp, AWD, Full load
02-12-2010, 11:53 PM #3
If the handle stays out the handle assembly needs to be replaced, I did a write up in the how to for my 99 suburban, even if your truck is not the same model style it will give you a good idea to what needs to be done. Handle assemblies from GM are 3599 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
02-14-2010, 11:32 PM #4
1993 SilveradoYesterday has been defined. Tomorrow is yet to come.
02-14-2010, 11:41 PM #5
I can just get to the rod clips for the inside handle and lock lever, but I cannot see the outside rods, and this is where I am having trouble.Yesterday has been defined. Tomorrow is yet to come.
By 05-Burb in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 4Last Post: 05-24-2010, 10:49 AM
By kuziwr in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 04-23-2010, 10:25 PM
By turo in forum Chevy Silverado Forum (GMC Sierra)Replies: 1Last Post: 02-09-2010, 02:35 PM
By 09rado856 in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 01-25-2010, 02:18 PM
By dboii313 in forum Audio, Video & Gadget TechReplies: 1Last Post: 08-10-2009, 07:29 PM
Tags for this Thread