Results 411 to 420 of 2390
12-30-2011, 03:21 AM #411
- Join Date
- Nov 2008
- Coventry RI
put a pin stripe and harley davidson badges on my Avalanche so I now have an HD Avalanche
12-30-2011, 08:27 PM #412
Removed the grille, removed the bumper, and bored two 7/16" holes in the frame in the proper position to bolt a warn hidden winch carrier into place. I then measured and made two 1/0 AWG cables to connect the winch to the secondary battery's positive and negative leads. I'll bolt it into place, tomorrow and connect up the electrical then, as well.
Last edited by SurrealOne; 12-30-2011 at 11:17 PM.
12-30-2011, 09:24 PM #413
Installed my Alpine KTP 445 amplifier and ordered 2 sets of KC Slimlites!04 ECSB Custom silver & grey, Soft 8's, BFG KO's, ReadyLift Leveling Kit, Hellwig front sway bar, K&N filter, DeeZee EZ-Down, Rhino liner, Alpine CDE103BT, Rockford 6.5's, 12" V.A.T. Hammer Pro in a Subthump box, Alpine PowerPack amp, Hifonics amp, BackRack w/ 55w 5000k HID KC Daylighters, KC light bar with 4 KC Slimlites, UWS toolbox, Shaved Antenna mod, Black Bowtie, LED backup, license plate, dome lights & 3rd brake light
01-01-2012, 05:38 PM #414
Beautiful day today so I washed and dried it and then tried out my new Porter Cable polisher. Sweet. Thanks Santa!2009 GMC Sierra 5.3L running on E85
Black and chrome
Borla dual exhaust
Chrome Billet grill
4300k High/Low Beam HIDs
Westin Ultimate Bull Bar with PIAA 540s
Blacked-out tail and third brake light
01-01-2012, 06:24 PM #415
After visiting my sister this weekend had to stop at a car wash and spray off the tree sap, bird poop and pine needles.
Get off your horse and drink your milk -John Wayne
01-01-2012, 06:34 PM #416
Replaced OEM parking lamp assemblies with LED parking lamp assemblies. Replaced OEM 194 bulbs for license plate lights, courtesy lights, and map lights with LED 194 bulbs. Mounted wireless remote holder for Warn winch in overhead bin. Pre-stressed the winch cable. Added a 9x12 tarp and a ball pein hammer to equipment in the truck box. Discovered scratches from cat claws on driver's side of hood and nearly killed the parental units' cat. Made a note to try to buff out scratches tomorrow... *sigh*
01-01-2012, 06:48 PM #417
01-01-2012, 10:39 PM #418
Took the mud off the tires. Washed and waxed. Had nail removed from one tire and repaired. Had Discount tire remove old tires from bed and dispose of them.
Those guys at my local Discount Tire are great at taking care of all my tire needs. Just wish they would add alignments to services offered.2010 Chevy Silverado Z71 ext cab.4x4
72 Monte Carlo 350-415 hp- sold (June 2011) to pay medical bills
79 Impala 350 4bbl 375 hp- sold (June 2011)to pay medical bills
"If He asks you to go a mile go two"
01-02-2012, 04:30 PM #419
i had my fuel pump and filter replaced a couple days ago i now have a working gas gaugeGo-Recon "xtreme" amber scanning tail gate light strip, Cobra ultra2 CB radio W/ 4 foot firestix antennas, dual exhaust with 40 series single in dual out muffler, 305/65R17 Mickey Thomson Baja ATZ on 17 inch Mickey Thompson Side Biters, 3 inch body lift
"when the going gets tough the tough get cyclic:fighting0019:"
"use the force luke:fighting0040:"
01-02-2012, 07:00 PM #420
Buffed out cat claw scratches from my hood using Meguirs ScratchX 2.0. (Amazing stuff.) Located the OnStar unit and disconnected it; got 80% of the way through removing it, completely, but had to stop because the temperature was dropping quickly outside. Will finish next weekend...
By ZSI52 in forum General Chevy & GM Tech QuestionsReplies: 47Last Post: 09-03-2012, 02:32 PM
By pmf608 in forum Chevy Truck TalkReplies: 21Last Post: 07-25-2012, 11:53 AM
By texas99lb in forum Chevy Silverado Forum (GMC Sierra)Replies: 10Last Post: 01-06-2010, 02:13 AM
By Delmarva in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 11-11-2009, 12:39 PM
By etpn13 in forum GM PowertrainReplies: 2Last Post: 04-22-2009, 03:45 PM