Results 1 to 1 of 1
Thread: 2004 Sierra 4.3l clutch issues
04-01-2010, 01:06 PM #1
- Join Date
- Mar 2010
2004 Sierra 4.3l clutch issues
Just recently purchased, vehicle drove great but slave was leaking. Dealer installed new slave and afterwards it is a little hard to get into first, reverse and has a slight notchiness into third.
If I try to put it in first when rolling slowly forward it slides right in, if not it often feels like I am having to give it a decent push and pushing past a rubber grommet or something.
If I rock it against the gate in first then back to neutral then first again it glides right in.
Since i bought this as is I think I will end up paying to have this handled or dealing with it myself.
I want to think it wasnt bled properly, how much am I looking at to have a dealer bleed it again and is it a pretty simple procedure.
By ajbellis in forum Chevy Colorado Forum (GMC Canyon)Replies: 7Last Post: 07-08-2011, 09:17 PM
By okysmokey911 in forum Chevy C/K Truck ForumReplies: 18Last Post: 01-25-2010, 08:21 PM
By ericevans14 in forum General Chevy & GM Tech QuestionsReplies: 20Last Post: 08-12-2009, 08:50 AM
By bgmotorsports in forum Chevy Colorado Forum (GMC Canyon)Replies: 2Last Post: 03-04-2009, 11:39 AM
By skooba0201 in forum Chevy Silverado Forum (GMC Sierra)Replies: 5Last Post: 01-14-2008, 06:07 PM