Just recently purchased, vehicle drove great but slave was leaking. Dealer installed new slave and afterwards it is a little hard to get into first, reverse and has a slight notchiness into third.

If I try to put it in first when rolling slowly forward it slides right in, if not it often feels like I am having to give it a decent push and pushing past a rubber grommet or something.

If I rock it against the gate in first then back to neutral then first again it glides right in.

Since i bought this as is I think I will end up paying to have this handled or dealing with it myself.

I want to think it wasnt bled properly, how much am I looking at to have a dealer bleed it again and is it a pretty simple procedure.