Results 1 to 10 of 10
Thread: west cost mirrors???
03-15-2007, 04:04 PM #1
west cost mirrors???
does anyone know if it will be hard to install west cost mirrors??iv allways wanted them on my GMC 20 but i didnt know how hard it would be to install them if it is possable..Padraic O'Neill
1990 Chevy K-1500
305 5.0L short bed 4x4
new tune up..synthetic oil only..turbo 400 3 speed trans, 10 bolt rear end just flushed both axles and added royal purple full synthetic gear oil...
04-02-2007, 10:51 AM #2
04-02-2007, 11:28 AM #3
- Join Date
- Dec 2004
- Arlington, Texas, United States
- Blog Entries
I'm not sure what you're looking for? Have a photo of it?
10 Chevy Traverse LT AWD
02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
99 Chevy Cavalier LS (105K+ miles - commuter car)
78 Chevy Suburban Silverado (454, 3/4 ton)
62 GMC 3/4 ton Pickup (350 police interceptor)
Remember: Search Before Posting | Fill out Your Profile & Signature
* I've been saying for years that I was going to change my username, and I finally did.
04-02-2007, 12:39 PM #4
are you talking about these?
04-02-2007, 03:33 PM #5
04-02-2007, 03:38 PM #6
haha well yeah same thing..jsut not liek that..ones that look better atleast haha ones that will look good..but yeah same thing how it connects over the window and under the window with the two bars leading to the mirror
04-02-2007, 03:45 PM #7
I'm thinking it would take some fab work to get the bracket to work. They usually go on doors with a square frame, like a van door. Your truck door is going to have an angle on the front so you'd have to have something that still brackets into the existing mirror mounting location.
It could be done, but I'm not sure how it would look. If you wanted it bad enough you could probably make it work, and make it look pretty good too.
Be a pioneer. Be the first, and start a trend!!
04-04-2007, 03:59 PM #8
yeah it will take alot of work lol i know it allready...so what should i do about the mirrors in the first place..go to a junk yard and get a set that came off a 1990 chevy/gmc??and look at how they were fabricated??
04-12-2007, 08:54 PM #9
it really seams like you should be able to buy a set that will bolt on to your truck just have to be carful drilling any holes in the lower door not to get any thing else like window frame lock bar or handle bar so any way good luck post a pic when you get them on I would like to seeCorey M (CoDaChrome™)
the vehicles I have/had
1989 GMC 2500 4wd (Sold)
1989 Palomino hard-side popup
1990 GMC 2500 pickup 2wd
1993 Jeep Grand Cherokee Limited (Beater) (sold)
1997 GMC jimmy sle 4wd (Sold)
1999 Silverado Z71 offroad
2000 Sunline 30' travel trailer
2003 Silverado Z71 offroad
2006 Yamaha wolverine 450 4wd
04-25-2007, 07:40 AM #10
lol yeah im kinda retarted...sooo im gonna fabricate the mirrors and mounts and have someone who knows what they are doing do the drilling and installing haha but i will post a pic when they are done
By captrcpjr in forum Chevy Silverado Forum (GMC Sierra)Replies: 2Last: 01-08-2010, 09:12 PM
By captrcpjr in forum Audio, Video & Gadget TechReplies: 0Last: 01-06-2010, 08:42 PM
By captrcpjr in forum Audio, Video & Gadget TechReplies: 0Last: 01-06-2010, 06:57 PM
By ChevyFan in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 0Last: 04-23-2008, 11:30 PM
By MotorheadRQ in forum Member IntroductionsReplies: 5Last: 07-23-2007, 07:28 PM
Tags for this Thread