Results 1 to 1 of 1
Thread: 1998 Chevy 1500 Tranny question
06-02-2010, 09:55 PM #1
- Join Date
- Feb 2010
1998 Chevy 1500 Tranny question
I bought a '98 1500 cheyenne with the 4.3 v6 and manual transmission. Not long after buying it, the shifter broke loose. It turned out to be the coupler that the shifter goes into. The one that is on the rail with a pin holding it in place.
I ordered the part, but I am having some trouble getting it installed. I figured the easiest way to replace it would be to disconnect the drive shaft, and then separate the small front piece of the transmission from the rest. I have run into two problems so far.
First of all, I cannot get the front part of the drive shaft out! I have the rear out and everything, but I can't get it out. Secondly, I have all of the bolts out of the smaller part of the transmission, but I can't get it to break loose. It looks like there may be a pin there that has to be driven out? Any help wouldbe appreciated!
Here is a pic to kind of help explain. I am trying the remove the part circled in yellow because the part I need to replace is about where the red circle is.
Last edited by jakeolsen; 06-02-2010 at 10:02 PM.1998 Chevrolet 1500. 4.3L v6. Manual Transmission.
By Steve in forum Chevy Trucks For Sale eBayReplies: 0Last Post: 05-09-2010, 10:00 PM
By Steve in forum Chevy Parts eBayReplies: 0Last Post: 03-05-2010, 05:30 AM
By scewter in forum Chevy Silverado Forum (GMC Sierra)Replies: 4Last Post: 09-29-2009, 02:02 AM
By bigburge in forum Member IntroductionsReplies: 6Last Post: 07-19-2009, 11:56 AM
By Steve in forum Chevy Trucks For Sale eBayReplies: 0Last Post: 06-23-2009, 07:40 PM