Results 1 to 3 of 3
Thread: new to 4x4
06-13-2010, 11:55 PM #1
new to 4x4
so i had just purchased my 2000 2500 yesterday and i was looking at leveling it out and i looked at full inspection of my truck underneath it has a huge driveshaft looks new and i was looking at torsion keys/bars noticed the bolts stuck out prbaby a 1/2 inch or so if i tighten them will that lift it more in the front? i am going to eventually do add a leafs in back and do a front axle swap and i promise to get pics up tomorrow. Also my T case seems to be covered in some oil and i noticed at the top there was almost a oil overflow hose that cuts off i will get pics up tomorrow after work but i really have not much clue about the 4wd drive train since im new to them buti love the truck so far although todayi had to buy a new battery
2000 Chevy Silverado 2500 4x4
6.0L v8:great: 4L80E
2.5 in Daystar leveling keys
285/75/16s BFG ATs on HD wheels
Cab lights and tool box
06-14-2010, 02:22 AM #2
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
Congrats on the new rig.. And to be safe i would just go and get the lifting keys.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
06-14-2010, 12:23 PM #3
That cut off 'overflow' hose may be the diff vent, it is supposed to extend up into the body so you don't get water into the diff. After you service the diff fluids, extent the vent back up...Still Loyal to GM after all these years...:shocked:
2006 Impala LT 3.5L
2005 Silverado WT small cab/longbed 4x4 4.3L V6
1999 Grand Am 3.4L in TX w/ our youngest
1993 GMC Jimmy 4.3L 4 door 4x4 'Ole Rusty' - 'SOLD'
1988 S-10 small cab/longbed HT3.4L Crate Engine
1970 Nova 250 I-6, factory 3 sp floor shifter.
1968 Chevelle 'Nomad' Wagon 250 I-6 w/ 3 on da' tree.