Results 81 to 90 of 90
Thread: Sea Foam in Vaccuum Lines
05-23-2013, 10:02 PM #81
you mean hydro-boost?
just use the PVC, dudeGas was $1.83 when Obama took office.....
05-23-2013, 11:22 PM #82
Seafoam per MSDS:
Pale Oil 40-60%
Isopropyl Alcohol 10-20%
Berryman's B12 per MSDS:
Methyl Ethyl Ketone <5%
Isopropyl Alcohol <5%
I might consider dosing my tank with B12 if I were going to drive and burn all 34 gallons in one shot. Maybe. But I'm cautious, like that.
Here's the official video of how to do it for a carbeurated or fuel-injected vehicle (a la the brake booster line). Notice the speed at which they pour it into the brake booster line, since this is an official video...
Here's another of seafoam going in the brake booster line. I'm pretty sure you DO NOT want to do what this guy does, as he lets it suck so much into his engine that it kills it. (There's probably a hydrolock risk doing it this way, and comments seem to be against how fast he does it, too..)
This one's probably better?
Most people seem to be against putting the stuff in one's oil...
Last edited by SurrealOne; 05-23-2013 at 11:45 PM.
05-23-2013, 11:42 PM #83
oh yeah lol
D is for dyslexia, kids!!!
05-24-2013, 12:25 AM #842000 Chevrolet Silverado
4.3L V6, 4L60E, 2WD, Single Cab
Poweraid TB Spacer
Flowmaster 10-series exhaust (dumped)
Edge CS insight monitor
LS-1 Dual Electric fans
Corvette tranny servo swap
Head Unit: Alpine
Speakers: Alpine SPR-60C 6.5" component set, 4X6 Infinity Kappas
Subs: 2-12" Kicker CVT's
Amps: Alpine-M1000 (subs), Alpine MRX-F65 (Speakers)
305/70R16 NITTO Terra Grapplers
16" PROCOMP 7089's
2" leveling kit
3" Fabtech Spindle Lift Kit
Front/Rear-Bilstein 5100 shocks
35W HID Low Beams
RECON LED smoked roof cab lights
HELLA LED taillights and 3rd brakelight
HELLA FF-75 Aux. Reverse Lamps
RIGID dually D2, flush mount, wide beam
Hawk HPS Brake pads
Russell braided steel brake lines
Powerstop-red powdercoated brake calipers
Powerslot Cryo brake rotors
EGR in-channel window visors
05-24-2013, 07:33 AM #85
- Join Date
- Dec 2011
- Blog Entries
I used it in my oil and it did a great job quieting my lifter tick. It says on the bottle to only keep it in the oil for 50-100 miles and then change the oil and filter.
1996 Chevy Tahoe LT 5.7L V8 4X4 205,000+ miles. Built proudly at Janesville Assembly in Janesville, Wisconsin
Basic mods: Lights all over, bunch of electrical work, and a couple cooling mods.
Check out my other mods in My Garage: http://www.gmtruckclub.com/forum/sho...t-Tahoe-4-Door
06-19-2013, 03:15 AM #86
- Join Date
- Jun 2013
- 1391 N Jefferson St., Anaheim CA 92807
The purpose of seafoam is to break down the carbon buildup in your injection system and block. It doesn't affect anything [good or bad]. It wont hurt your motor at all.
10-04-2013, 10:52 AM #87
Gonna try it in both tanks of the truck and car (alero). Each have about a 1/2 tank so half a bottle per car. Both have 170,XXX so hopefully I will see some improved mpg!-K&N Air Filter
10-07-2013, 06:32 AM #88"i dont think you got the picture. i got a beautiful picture. this baby happens to have an extra turn of speed, which is the only thing i care about. you dont understnad what happens do you? they make cars. they make 'em exactly the same way. one or two of 'em turn out to be something special. nobody knows why. i know why. i may be kiddin' myself, but i think i can make somethin' out of that sad little bucket of bolts." ~ Tennessee Steinmetz
10-07-2013, 09:41 AM #89
11-01-2013, 02:05 PM #90
By 98-chevy in forum General Chevy & GM Tech QuestionsReplies: 9Last: 09-27-2010, 08:45 AM
By FergusonT in forum Maintenance & UpkeepReplies: 24Last: 09-11-2010, 11:14 PM
By socal77k5 in forum GM PowertrainReplies: 1Last: 06-08-2010, 03:10 PM
By dsquared in forum GM PowertrainReplies: 5Last: 05-26-2010, 07:59 AM
By Chad01 in forum Performance & FuelReplies: 6Last: 02-17-2010, 12:09 PM
Tags for this Thread