Results 1 to 4 of 4
Thread: 87 suburban front drive shaft
06-26-2010, 02:49 PM #1
87 suburban front drive shaft
i have a 87 suburban V20 5.7 lt 350 cu, i have it lifted 4 inches on 33 inch bfgs. when i bought the truck the drive shaft was not on. i went to match it up and it doesnt fit, is there a cheap way to get the length and or angle to match up better? oh and its the FRONT drive shaft. not the rear. the rear yoke is a slip yoke and isnt a snug fit with the lift1987 Chevy Suburban 4x4 - Lifes a garden, dig it, gotta keep on keepin on!
06-26-2010, 05:39 PM #2
check out 4 wheel parts, they sell an ext that is about 55 bucks.
D44/14BFF w/Disc conv - Yukon 4:88's - Yukon Grizzly Lockers F/R -13" lift - DIY4x Shackle Flip - 37 ATZ on 18 MT Classics - Doug Thorley headers - Magnaflow - Holley Pro Jection Intake - Ultimate TBI mods - Hydroboost Brake Conversion - Hysteer-X Over Conversion.
(Coming up - Fuel Injected 383 Stroker - Divorced NP205 - D60 - 40" tires)
06-28-2010, 03:02 AM #3
your talking about the drive shaft spacer right?
07-05-2010, 12:17 PM #4
yea last time i looked thaey were about 50 to 60 bucks
By Minnesota Mudder in forum GM PowertrainReplies: 0Last Post: 02-15-2010, 12:31 AM
By dsfloyd in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 07-29-2009, 11:09 PM
By homer911 in forum General ClassifiedsReplies: 0Last Post: 02-16-2009, 11:25 PM
By 95burban in forum General ClassifiedsReplies: 0Last Post: 12-29-2008, 10:00 PM
By homer911 in forum General ClassifiedsReplies: 0Last Post: 11-10-2007, 08:43 AM