Results 1 to 3 of 3
06-30-2010, 12:31 PM #1
The Beast has a stu,stu, stutter! Help!!!
Sorry if this gets long winded.
My suburban is having a random stutter at idle and upon take off from a stand still you can feel it bogging a tad (randomly as well). it is very intermittent and when it is happeining its not even either like on cycle with the firing of the spark plug. It has a new fuel pump, filter and the fuel pressure is solid. when sitting at a light or stopped with the foot on the break and only after it gets closer to operating temp there is a sputter, and the truck will shake like its gonna die but only for a split second. The tach will jump ever so slightly and you can hear a crackle/pop, like the ignitor on a gas stove/grill. It really only does it when the truck is in gear so its hard to check and see if the wires are arching or something, but also am beginnning to wonder if this is fuel injctector related. if i am steady on the gas the exhaust is fine but if I am rolling and I hammer it there is some black smoke out the pipe like it is running rich. Again leading me to believe there is an injector problem. I am gonna run some seafoam in the gas and through the brake booster line and see what happens. So if it is the injector how do I isolate it to figure out which one (would it be evident on the plug?) Or is it really a crap shoot, I have no SES/CEL either. Thanks in advance!!99 K1500 Suburban LT "THE BEAST"
Hypertech III, K&N, true dual
06-30-2010, 12:56 PM #2
Even though the SES is off, I might pull codes anyway -- there may be pending codes that will help to isolate the problem.
The crackle/pop makes me think of an ignition issue more than an injector issue. The injectors are buried inside the intake where any sound they would make would be muffled. Have you tried using a spray bottle to spray water mist around the wires/distributor/etc. to see if you can induce a spark leak?'98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
'92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
"My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World
06-30-2010, 10:32 PM #3
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
Check the bushings in the Distributor.. They are plastic in the Vortecs, and the bushings go out.. That honestly sounds just like one that my buddy had a problem with at first then the stumble got worse.
And as MrShorty said the injector assembly is buried under the upper intake. You might have a fuel pressure regulator problem or else possibly a torn injector line.. I dont know if you have seen what they look like but the spider assembly holds the injectors and they use plastic lines to route the fuel to the cyl.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
By White Gardens in forum GM PowertrainReplies: 8Last Post: 04-08-2010, 04:29 AM
By jordan.coquat in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 02-25-2010, 06:59 PM
By vncj96 in forum General Chevy & GM Tech QuestionsReplies: 4Last Post: 11-22-2009, 11:35 AM
By thrasher in forum Photo & Video GalleryReplies: 10Last Post: 01-07-2009, 08:59 PM
By 88 Dually 4x4 in forum Photo & Video GalleryReplies: 14Last Post: 11-07-2007, 01:29 PM
Tags for this Thread