Results 1 to 6 of 6
06-28-2010, 12:45 AM #1
No torque in 4HI, acting sluggish
I noticed the other day when i bogged down in some mud that when I shifted into 4hi my rpms wouldn't climb over 1.5, would just barley turn my tires just not enough to get out. I wasn't in anything deep or nasty just some sand and water nothing bad, so I locked it into 4low and it crawled right out with no problem. My question is what could be casuing my truck not to rise over 1.5 rpms in 4hi (btw that was having the pedal to the floor) I just dont have the slightest clue what it could be.
06-28-2010, 03:32 AM #2
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
There is a posibility that the tranny was stayed in 2nd gear.. Also the sand might have grabbed the tires enough to not allow the power that you were looking for.. have you tried the 4hi out on a normal surface? I know that my truck doesnt pull hard at all in 4hi and boggs pretty good when im pushing it off road.. I usually use 4lo just to be sure i dont get in to much trouble.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
06-28-2010, 11:38 AM #3
Any other reason to think there's a problem? I'm not sure I necessarily see a problem based solely on what is posted here.
'98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
'92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
"My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World
06-28-2010, 12:25 PM #4
Guys i really apperciate the input , I just wasn't sure about it, being i know jack squat about transmissions. Yall have eased my mind cause that is really the only thing i've noticed that got me worried thanks agian
06-29-2010, 05:16 PM #5
- Join Date
- Dec 2004
- Arlington, Texas, United States
- Blog Entries
I've done my share of wheeling and sand has advantages and disadvantages for good wheeling. Wet sand though it heavy and it binds stuff up pretty tight. Did you have full air in your tires at the time, or were you trying to float your tires with low PSI on top of the sand, like going in sand dunes?
Driving in sand is always tricky, so they say to always keep your momentum when driving in a tight sandy spot. We used to lower the pressure down to about 10 psi or even lower when wheeling in sand dunes. This is one primary reason, the wheels get very rigid and don't do well in sand at times.
10 Chevy Traverse LT AWD
02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
99 Chevy Cavalier LS (105K+ miles - commuter car)
78 Chevy Suburban Silverado (454, 3/4 ton)
62 GMC 3/4 ton Pickup (350 police interceptor)
Remember: Search Before Posting | Fill out Your Profile & Signature
* I've been saying for years that I was going to change my username, and I finally did.
06-30-2010, 01:27 AM #6
I actually had full pressure in my tires, I had gone on a road trip the week before. I usually bag them down when I'm in sand but didn't bother with it this day.
By Gatorfan71 in forum Performance & FuelReplies: 5Last: 07-16-2010, 07:41 PM
By jdog468 in forum General Chevy & GM Tech QuestionsReplies: 9Last: 04-06-2010, 02:07 PM
By Ron Inverso in forum General Chevy & GM Tech QuestionsReplies: 2Last: 08-26-2009, 07:29 PM
By ChevyFan in forum The Coffee Shop ~ Chit ChatReplies: 0Last: 06-23-2008, 08:10 PM
By ChevyFan in forum Announcements & FeedbackReplies: 4Last: 06-05-2007, 02:53 PM
Tags for this Thread