Results 1 to 4 of 4
Thread: coolant temp sensor
07-14-2010, 06:24 PM #1
coolant temp sensor
So i was changing out my negative battery cable today and bumped my hand on the coolant sensor that threads into the intake manifold, and i guess after 15 years the plastic became brittle so it snapped right off. from what i can tell this just sends a signal to my dashboard for my temp reading.
Does anyone know if i can leave it unhooked and still drive the truck until i get a new sensor this weekend? Also, what are my chances of actually being able to unthread the sensor after 15 years?
1995 Chevy truck
223,000 miles and counting
:fighting0098: chaos, panic and destruction...my work here is done
GM ALL THE WAY BACK
2007 Chevy Imp
2006 Chevy Colbolt
07-14-2010, 07:29 PM #2
Its prolly not going to run very well, im sure it will throw a check engine light and run in limp mode. the coolant sensor dosent just run the gauge it also tells the computer how hot the motor is obviously, but it also has to do with timing and fuel trim.
07-14-2010, 11:27 PM #3
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
You broke the Sensor and not the switch right?? the sensor will make your truck run rough since it sends the temp to the computer to determin your fuel trims, and the switch mounted in between the #1 and #3 cylinders on the head. The Switch is what sends the signal to the guage on your dash.. It wont even really go into limp mode it wil just run really really rough.. So id advise that you dont drive it.. The switch should be about $15 mabey less.. I just had to replace mine on my old truck.. And it is a brass fitting it will actually come out quite easly.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
07-15-2010, 05:06 PM #4
Thanks for the info guys. I changed it out tonight with no issues.
By Googenheimer in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 02-23-2010, 03:43 PM
By Googenheimer in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 02-22-2010, 12:50 PM
By thekingsphance in forum GM PowertrainReplies: 3Last Post: 08-12-2009, 11:20 PM
By Crawdaddy in forum GM PowertrainReplies: 6Last Post: 11-08-2008, 07:32 PM
By kbarrett in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 07-16-2007, 10:10 PM