Results 1 to 4 of 4
08-04-2010, 01:00 AM #1
How to trim front for tire clearence?
Has anyone done a how to or do you just take a saws-all and hack at it?
Do you have to remove the casing around or can you just push it back after trimming?
I need to remove no more than a quarter of an inch...2005 Sivlerado Z71 LT
Summit White w/ 5.3L V8
Extended Cab, Leather Interior, XM/On*
- Front Headlight and Parklight covers
- Brakelight Covers and Blacked Out Third Brakelight
- Front Grille Bow Tie Blacked Out
- K&N Cold Air Intake
- Magnaflow Catback Dual Exhuast
- Truxxx Lift and Level Kit
- Toyo Open Country M/T 33x12.5x18 Tires
- Pro Comp Series 8101 18x9.5 Rims
08-04-2010, 02:17 AM #2
What part do you want to trim. If its the bumper or inside the fender I use a die grinder with a cut off wheel. Than I spray with a little undercoating.
08-04-2010, 11:04 PM #3
It's inside the fender towards the rear. I already did the trimming by the bumper which was super easy.
08-05-2010, 10:58 AM #4
I trimmed the fender also with a cut-off wheel, then undercoated it.
By RigRunner in forum Chevy Truck Tech ForumReplies: 2Last Post: 06-24-2010, 09:50 AM
By pmartin816 in forum Chevy Truck AccessoriesReplies: 7Last Post: 03-10-2010, 08:32 AM
By kawasaki_kid in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 01-25-2010, 12:24 PM
By beakerss in forum Chevy Silverado Forum (GMC Sierra)Replies: 5Last Post: 10-21-2009, 12:33 AM
By fishpolz in forum Chevy Truck AccessoriesReplies: 2Last Post: 04-10-2009, 03:46 PM