Results 1 to 6 of 6
Thread: Spider test on a 5.7 Vortec?
08-18-2010, 03:04 PM #1
Spider test on a 5.7 Vortec?
Is there a way to test the spider while its out of the truck?
The Local shop had said it might be the spider.(we don't have any really reputable ones in our local area...small town with worst services ever!)
When we pulled it apart the intake gasket was shot, and while replacing it I started wondering can you test the spider? How do you do it??2000 & 2001 Chevy Prism
1999 K1500 Suburban 5.7 Vortec
Shouldn't they call it Truck Tape instead??
08-18-2010, 03:06 PM #2
I think that GM might have a way.. I know there are a few Service techs on here so they might know a bit more. But i think there is a away...
And if you dont mind me asking whats it doing??Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
08-18-2010, 03:10 PM #3
Had a couple cyl fouling out on the passenger side, as well as all the typical bad intake gasket signs loss of oil/coolant(found out the signs on here thanks all!)
The shop said "oh its the spider" of course they would have to do the intake gasket at the same time.......or so they said.
08-18-2010, 03:14 PM #4
Wow.. I would do the intake gaskets first.. They dont have to do intake gaskets to replace the spider, since to get to the spider it is just the Upper intake that has to be removed. However the Intake gaskets require you to remove the lower intake which is what the Spider is mounted to.
I would just start with the Intake gaskets.. Because that will cause the most trouble..
08-18-2010, 03:21 PM #5
Yeah we are in the middle of the intake gaskets now. While cleaning parts last night I just started wondering about it...
Replacing the belt , the fuel presure reg(just because its inside...) the tensioner, some hoses, the heater hose quick connect, the gaskets...
Tried cleaning the alum lower intake with easy off & a pressure washer, my future son in law does it on his LS trucks all the time worked pretty good, was quick and easy. Wish I had thought of that 20 years ago....
08-18-2010, 03:27 PM #6
Well let us know how it turns out.
By Steve in forum Chevy Volt ForumReplies: 7Last Post: 05-18-2010, 11:53 AM
By crrn204 in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 02-17-2010, 10:39 AM
By winsonca in forum Chevy S10 Forum (GMC Sonoma)Replies: 0Last Post: 04-21-2009, 12:26 PM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 5Last Post: 02-16-2008, 09:34 PM