Results 1 to 6 of 6
10-01-2010, 10:07 PM #1
Found a plug hanging near radiator........2006 silverado 1500 LT1 4X2 ecsb 6.0L, front mount T76 turbo intercooled, Detroit true trac, 3.23, Chevrolet black chrome 20"s, Nelson performance tune! magna flow muffler with dual exhaust with QTP cut out. ET-14.001 @100mph spinning.....
10-01-2010, 10:23 PM #2
I can't tell from the picture but is there a cover on the end of the plug? Sometimes the manufactures run a wiring harness to cover differant options and maybe it wasn't used on your truck. If it doesn't have a cover then just take the plug and move around the area that is the length of the wire and see if you can find a matching plug. Hope I explained that so you understand.
10-01-2010, 11:06 PM #3
Yes, I just went out side and did that, The wire / wire loom runs in front of the radiator base and looks like it might mount in a bracket/L shaped metal bar that runs infront of radiator. still not sure what this is for??
10-01-2010, 11:11 PM #4
But does it have a cover on the end of the plug or is it a open plug?
10-02-2010, 11:38 AM #5
Some models had a horn right in front of the radiator. That's what the plug's for....
10-02-2010, 01:08 PM #6
I think its an open plug.
its got a sensor of some sort.
By Kraziken in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 7Last Post: 05-05-2011, 04:20 PM
By gkipe in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 09-23-2009, 04:18 PM
By cindon27 in forum General Chevy & GM Tech QuestionsReplies: 6Last Post: 08-12-2009, 06:07 PM
By Steve in forum Chevy Volt ForumReplies: 0Last Post: 08-03-2009, 03:30 PM
By Cableguy in forum The Coffee Shop ~ Chit ChatReplies: 3Last Post: 05-30-2007, 08:56 PM