Results 1 to 3 of 3
Thread: EGR install on 84 GMC 350
11-18-2010, 09:23 PM #1
- Join Date
- Nov 2010
EGR install on 84 GMC 350
Hey all. Getting back to my old project 84 GMC. Its time to put the EGR valve on and I am looking at the Edelbrock intake I got and the port is just wide open into the lower area of the intake. It kinda seems like if I put on an EGR or not its just going to breathe right past it into the main part of the intake. Am I missing something here???
I am going back to carb from TPI and dont have my original carb parts anymore to remind me how it was setup before!
11-18-2010, 10:52 PM #2
- Join Date
- Sep 2010
- Far West, Oregon USA,
- Blog Entries
Welcome to the Gm truck club Chevelle. If you ordered the Edelbrock manifold for the same year as what the egr valve used to fit, then it will work.
If you have a 70 Chevelle post a pic.1988 Chevy C-3500 2wd (no pic)
350 c.i. 5.7 L Stock Block, 4 Bolt Mains
L-31 Vortec Heads, Edelbrock Cam & Intake,
Holley 650, Flowtech Headers, Magnaflow exh.
Jet Trans 700R4, B&M Ratchet, 4:10 gears,
3" susp. lift kit "shadetree"
No rev limiter, No speed limiter lol
10-29-2011, 06:40 PM #3
They make a plate you can put over the egr hole but if it runs off a computer i would put an egr on it because it has to do with the map sensor and fuel reburn.
By ИorτнRoαdΛĸ907 in forum Chevy Truck AccessoriesReplies: 5Last Post: 04-29-2010, 02:07 PM
By silverado joe in forum Chevy Truck AccessoriesReplies: 2Last Post: 01-23-2010, 07:08 PM
By SmokeU in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 10-24-2009, 10:57 PM
By justaphase44 in forum Performance & FuelReplies: 4Last Post: 03-18-2009, 09:16 AM
By Drifter in forum Audio, Video & Gadget TechReplies: 7Last Post: 04-09-2008, 12:53 AM