Results 1 to 5 of 5
Thread: Door striker replacement
12-13-2010, 05:01 PM #1
Door striker replacement
It appears that I'll have to replace the door striker bolts on my '89 burb. The plastic bushings are breaking due to age and abuse and the bolts are deformed due to misalignment. I'd like to know if anyone else has done this and if they have tips or techniques to share. Does the striker fit into a fixed nut in the "B" & "C" pillars or will I have to remove the interior trim to access them.
Any advice will be appreciated
1989 R1500 Silverado Suburban
5.7L, TBI w/ Dual remote oil filters,
16" 2010 CFM E-fan, K&N filter
TH700R w/ Aluminum pan, remote trans fluid filter and aux trans fluid cooler
Air shocks rear,
7x16 dual axle cargo trailer; 10K Reese HD trunnion bar WDS, dual friction sway dampeners
Cuz....I like to move it, move it....
12-13-2010, 09:49 PM #2
- Join Date
- Nov 2010
- Ogden, Utah
The striker unscrews and the new one will screw right in. Also check you door hinges for wear. With the door open, grab ahold of the bottom outside edge and lift. If there if slop in it, or movement, then the hinge pins are worn too and are in need of replacement. More than likely the hinge pins and bushings will need replaced, so do this at the same time as the striker. The striker is adjustable, so tighten it enough where it will just hold itself in place, but you can move it by tapping lightly on it with a mallet. Put it about the same place the old one was and shut the door. Then open it again, and it should be close to the correct place for the door to shut tight without riding heavy on the striker. If the door does not shut tight, move the striker in a small amount by tapping on it, then tighten it snug and try the door again, repeat this until the door fits tightly closed but opens easily.
12-20-2010, 02:56 PM #3
Thanks, but is the nut that the bolt screws into in some type of retainer? I'm curious to know if I have to secure it so that it doesn't fall down into some dark, dusty recess.
12-20-2010, 08:37 PM #4
- Join Date
- Jan 2007
- Jamestown, ND
I have replaced the striker before. If the nut falls off, you can take the interior trim off and there is an access hole to retrive it. some stay put, some fall down in the pillar.
12-22-2010, 01:51 PM #5
Thanks to both grandparon & inspectormatt for your advice.
By billydove in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 2Last Post: 06-23-2010, 11:01 AM
By Silverado Junkie in forum How-to GuidesReplies: 0Last Post: 06-10-2010, 08:49 PM
By jet89 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 03-23-2010, 06:29 PM
By tbolivar in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 12-16-2009, 02:56 PM
By makthenif in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 0Last Post: 02-01-2008, 12:43 PM