GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default Removing driver door panel on 1999 tahoe

    I have to replace the window motor on the front drivers side of
    my 1999 Tahoe. The thermal fuse keeps opening and I have
    to wait in between attempts to raise/lower the window. Are
    there any instructions available on removing the panel???????

  2. #2

    Default

    Bottom is held in by those christmas tree retainers. Pry gently outward with a putty knife. Mid way up theres some screws in around door handle. Once everything is undone. Gently lift upwards, theres clips up by window trim., That will let go and panel will pop out. Go easy pulling it away as to not pull on wiring to hard, then undo from bottom of power window switch.



    Jamie

    2007 Ford E250(Work van) (Ya, Ya, shut up!)
    1996 GMC Sierra SLE 1500 5.7L/4L60E

  3. #3

    Default 1999 Tahoe Door Panel

    Thanks.
    I followed the advice and the panel is now off. Now I just
    have to figure out how to change out the window motor. I
    took the door speaker out and I am hoping (tomorrow) I
    can get my hand in there to change it.

Similar Threads

  1. 99 Tahoe driver door sagging, won't close correctly
    By sresendes in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    Replies: 12
    Last: 04-20-2010, 07:15 AM
  2. Remove rear door panel on 2002 tahoe
    By rgonline in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)
    Replies: 2
    Last: 12-20-2009, 01:09 PM
  3. door panel removal 99 Tahoe
    By bassalive in forum General Chevy & GM Tech Questions
    Replies: 4
    Last: 12-08-2008, 02:56 AM
  4. WTB 1996-1999 2 door Tahoe/Yukon
    By SEL777 in forum General Classifieds
    Replies: 1
    Last: 10-06-2008, 04:31 PM
  5. 1999 2 DOOR TAHOE\YUKON front seats
    By maxumpower in forum General Classifieds
    Replies: 0
    Last: 02-28-2007, 09:39 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •