Results 1 to 1 of 1
02-05-2011, 05:20 PM #1
- Join Date
- Nov 2010
Do we need to Clear Codes on a Transfer Case and Actuator?
I just installed a newly rebuilt transfer case and actuator motor (actuator motor was used). Everything is buttoned up and ready to go, but we are getting a code thrown to us in the dash.
Service 4wd (This is what shows up in the dash)
When I turn the key the push button 4wd lights momentarily light up, but then shut off.
Now i have heard from others that we need to re-code the motor, in a sense wipe it clean? I have heard we need to push and hold 2 buttons, and then push down another button and that shifts it into neutral, and that should be it, but it is not working, or maybe we are doing it wrong?
do I need to connect a coder to the computer?
What is the correct process for the button pressing?
Any help would be greatly appreciated!
2003 Silverado, 6.0L
New process Transfer Case, Model 246Owned Pickups:
2003 Silverado 4x4 Crew cab 6.0L
1996 Silverado 4x4 Ext. cab 5.7L
By TXWagon in forum GM PowertrainReplies: 7Last Post: 07-20-2011, 05:01 PM
By tlavergne in forum GM PowertrainReplies: 2Last Post: 01-21-2011, 11:56 AM
By idowa in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 08-27-2010, 12:43 PM
By Demick in forum General Chevy & GM Tech QuestionsReplies: 4Last Post: 02-27-2010, 12:21 PM
By tareyton in forum GM PowertrainReplies: 1Last Post: 08-28-2009, 08:14 AM
Tags for this Thread