GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4
  1. #1
    Jr. Apprentice
    Join Date
    Feb 2011
    Location
    Philadelphia Pa.
    Posts
    22

    Default Turn signals & brake lights

    HELP !! I blew my turn signals and brakes lights.. The emergency flashers works. I roll a 1999 Silverado 454ci. 4x4 dually.Where do I find the fuses? or what do I do to fix this??

  2. #2
    Legend
    stephan's Avatar
    Join Date
    Sep 2010
    Location
    Far West, Oregon USA,
    Posts
    8,606
    Blog Entries
    1

    Default

    I think 96 & up have 2 fuse boxes. One is under the left side of the dash & there is a second one out under the hood. There should be a page in your owners manual that will guide you to the particular fuses. Hope this helps..
    1988 Chevy C-3500 2wd (no pic)
    350 c.i. 5.7 L Stock Block, 4 Bolt Mains
    L-31 Vortec Heads, Edelbrock Cam & Intake,
    Holley 650, Flowtech Headers, Magnaflow exh.
    Jet Trans 700R4, B&M Ratchet, 4:10 gears,
    3" susp. lift kit "shadetree"
    No rev limiter, No speed limiter lol


  3. #3
    Jr. Apprentice
    Join Date
    Feb 2011
    Location
    Philadelphia Pa.
    Posts
    22

    Default

    your reply is appreciated Stephan.. You were close.The fix for the turn signal's was the fuse box located on the end of the dash, drivers side.Owned the truck for near-on two years and never noticed the small door.. The fix for the brake lights was, putting the 30 amp fuse where it belonged in the fuse box under the hood drivers side lol..I took the fuse out yesterday ,cause I saw it had blown.I put the replacement in the wrong position hmmmmmmmmmm

  4. #4
    Legend
    stephan's Avatar
    Join Date
    Sep 2010
    Location
    Far West, Oregon USA,
    Posts
    8,606
    Blog Entries
    1

    Default

    lol, that stuff happens. Glad you got it fixed. My nephew once switched his start relay on his rice grinder into a blank hole & couldn't figure out why it wouldn't start cuz it worked fine before he touched it

    ** did you figure out why the fuse was blown? If not, then it may happen again.
    1988 Chevy C-3500 2wd (no pic)
    350 c.i. 5.7 L Stock Block, 4 Bolt Mains
    L-31 Vortec Heads, Edelbrock Cam & Intake,
    Holley 650, Flowtech Headers, Magnaflow exh.
    Jet Trans 700R4, B&M Ratchet, 4:10 gears,
    3" susp. lift kit "shadetree"
    No rev limiter, No speed limiter lol


Similar Threads

  1. 89 brake/turn signals messed up
    By finkenator9 in forum General Chevy & GM Tech Questions
    Replies: 0
    Last Post: 08-20-2010, 04:38 PM
  2. Rear LED Turn Signals and Brake Lights
    By Chevy Young Blood in forum Lighting Discussion
    Replies: 3
    Last Post: 12-08-2009, 02:12 AM
  3. lights and turn signals
    By lowriderinms in forum Audio, Video & Gadget Tech
    Replies: 5
    Last Post: 07-29-2009, 12:17 PM
  4. Turn Signals, Stop Lights, and the Stereo
    By HM_Hauler in forum General Chevy & GM Tech Questions
    Replies: 3
    Last Post: 06-01-2009, 02:12 AM
  5. Brake, Turn signals, and emergency flashers
    By da pope in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 13
    Last Post: 04-25-2009, 03:45 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •