Results 11 to 11 of 11
08-03-2013, 10:32 PM #11
- Join Date
- Aug 2013
+-Make sure you check the seal surface for build up or rough surfaces. Mine leaked to the first time I replaced the seal. I Used some 1500 wet sandpaper to smooth out and make a clean surface for the seal to ride on.. If your seals are still leaking after seal replacement, you may have a bad inner bearing. Check and replace as necessary.
- - - Updated - - -
Instead of buying this special socket to set the preload, I marked the slot that the keyway went in before I removed it with a sharpie pen. I then removed the keeper and keyway and used a screw driver and small hammer to loosen the nut. I took it off and completed the seal replacement, I then reinstalled the nut and lined it up with the line of the slot with the screwdriver and tapped it in place. This put it exactly where it was before I took it apart. If you replace the bearings, then you might consider retorking the nut with the socket to seat the bearing on the race.
By phoebeisis in forum GM PowertrainReplies: 7Last Post: 01-05-2013, 05:29 AM
By TJbear in forum GM PowertrainReplies: 5Last Post: 05-18-2010, 07:20 PM
By cmc474 in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 04-24-2010, 09:50 AM
By hdominic in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 12-23-2009, 07:19 PM
By OLD BLUE in forum Chevy Truck AccessoriesReplies: 7Last Post: 03-27-2009, 11:46 AM
Tags for this Thread