GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2
  1. #1

    Default Oil cooler line replacement

    Does anyone know how to replace the oil cooler lines on a 1999 K3500 w/ the Vortec 454? Any help would be greatly appreciated.

  2. #2

    Default

    It was not such a big deal, disconnect lines at radiator tank, remove the bolt at the motor mount holding the oil lines, then pry off the black caps at the connections at the filter, I used a hook bar, use a small pick and hook the E-Clip and pop them out and lines will slip out of the fitting. I found it very difficult to reinstall the E-Clips with the fitting still in the block, once the fitting were removed it was very simple to reinstall the E-Clips, reinstall the fittings with some sealent on the threads and then snap the lines into the fittings, push on the black caps, reattach the hoses at the radiator tank and and reconnect the suppurt bracket at the motor mount.

Similar Threads

  1. Oil cooler line replacement 2003 suburban 8.1L
    By Woodman in forum General Chevy & GM Tech Questions
    Replies: 6
    Last: 01-22-2011, 07:46 PM
  2. Replacement fuel line
    By geardrivensoul in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 2
    Last: 12-16-2010, 08:29 AM
  3. Oil cooler line install question
    By HeavyMetalMechanic in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 3
    Last: 03-31-2010, 05:19 PM
  4. Brake Line/Fluid Replacement
    By Crawdaddy in forum Lifted & Offroad Suspension
    Replies: 4
    Last: 10-30-2009, 02:32 PM
  5. cooler line,tranny failure,
    By gardnergrendal in forum GM Powertrain
    Replies: 2
    Last: 06-12-2009, 08:44 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •