Results 1 to 3 of 3
07-13-2007, 09:16 PM #1
- Join Date
- Jul 2007
Remote Programming Instructions 1998 Suburban
Item title: 1998 98 GMC Suburban Remote Programming Instructions
1. Locate the Data Link Port. It is located under dash drivers side.
Be sure you
know which pins are 8 and 4.
(Notice port is wider on top row)
2. Make sure there are metal contact pins in terminals 8 and 4. Connect
8 to 4
with a suitable jumper wire (leave the jumper wire connected throughout the
programming procedure). Make sure you know which terminals are 8 and 4. The
vehicle will respond by locking and unlocking the doors to signify entering
3. Press and hold both the LOCK and UNLOCK buttons together on the first
transmitter to be programmed. After about 15 seconds, the vehicle will respond
locking and unlocking the doors. Release the buttons on the transmitter.
4. Within one minute, repeat the previous step on the remaining transmitters
5. Remove jumper wire applied to the OBDII Port.
07-13-2007, 10:17 PM #2
Thanks Kevin! Good work.
2007 Ford E250(Work van) (Ya, Ya, shut up!)
1996 GMC Sierra SLE 1500 5.7L/4L60E
12-04-2007, 03:28 PM #3
- Join Date
- Dec 2007
- New Jeresy
Thanks Kevin, I used a paper clip to jump the 2 terminals and it work perfect. Now I have 2 remotes that work again. Thanks for the great info.
By Silverado99 in forum Chevy Silverado Forum (GMC Sierra)Replies: 2Last Post: 09-30-2009, 06:56 PM
By Steve in forum Chevy Keyless Entry RemotesReplies: 7Last Post: 09-22-2009, 04:33 PM
By chriSSpurling in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 10-09-2008, 01:15 PM
By Steve in forum Chevy Keyless Entry RemotesReplies: 4Last Post: 03-15-2008, 04:17 PM
By 96Tahoe4x4 in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 0Last Post: 12-06-2007, 10:35 PM
Tags for this Thread