Results 1 to 9 of 9
04-28-2011, 01:10 PM #1
- Join Date
- Dec 2010
Tonneau Cover: Best Soft for Over-Rail?
I have a 2009 Silverado 1500 crew cab short bed (5'8") with an over-the-rail bed liner.
I'm looking to purchase a tonneau cover - soft, that will work with the over-the-rail bed liner. I don't mind cutting the bedliner. Looking to spend no more than $250. Any suggestions?
04-28-2011, 01:34 PM #2
- Join Date
- Jul 2010
- Denver, CO
- Blog Entries
I have a Truxedo that sits above my bed rails. The cover itself sits a 3/4" about the bedrails and the tonneau cover railmounts mount directly on top of the bed rails. However, because the mounts used C type to mount, I ended up drilling a few holes on each side, thus not it does not stick out from inside of the bed rails. I think they are about $300 bucks though......it is model #:
TruXedo 263701 TruXport Soft Roll-Up Dual Latch Tonneau Cover
I'm sure your model # will be different, as I have a 6'6" bed
Last edited by mfleetwood; 04-28-2011 at 01:37 PM.
Mike (Denver, CO) - 2008 Sierra 1500 Z71 SLE 5.3L 4WD
SUSPENSION: Rancho 4" Suspension Lift; Rancho RS9000XL Shocks; Rancho Skid Plates; Rancho MyRide Wireless Shock Controller;
TIRES: BFG All Terrain KO 315/70/17
DRIVE TRAIN: 4.56 Gears; Detroit TrueTrac Differential; True Cool 40k Transmission Cooler
PERFORMANCE: DiableSport Predator Tuner; Custom Tuned by Diablew; Magnaflow Exhaust; AFE Cold Air Intake
ELECTRONICS: Kenwood DNX6180 Touchscreen; Subthump box w/10" Kicker; Driver Information Center (DIC); Rear View Camera
ACCESSORIES: Westin Brush/Grill Gaurd; Westin Nerf Bars; Truxedo Tonneau; 20% Tint; Tow Mirrors w/Heat & Signals
04-28-2011, 04:33 PM #3
TruXedo and Extang both have good soft tonneau's. Check out there websites, they have several that fit with over-the-rail bedliners.
04-28-2011, 04:47 PM #4
If you decide to go with the Extang, the snapless model is worth it for the ease of operation. I've had a snapless Extang now for 7 years and wouldn't be without it. I've had two trucks with Extang tonno's and like them very much.
04-28-2011, 05:25 PM #5
I also have a Extang snapless, had it since '05 and it still hanging in there. I just wash with truck every week and once a month use a protectant on it.
04-28-2011, 06:16 PM #6
I have the Extang 'Tuff Tono' which sits on top of the rail w/ 2 piece clips fastening the rails, the guy cut little windows in my liner.
No snaps, good warranty and it comes w/ a parts list if you do need stuff. One for my long bed was higher than a standard or shorter one. It was a little over $350.00 installed.Still Loyal to GM after all these years...:shocked:
2006 Impala LT 3.5L
2005 Silverado WT small cab/longbed 4x4 4.3L V6
1999 Grand Am 3.4L in TX w/ our youngest
1993 GMC Jimmy 4.3L 4 door 4x4 'Ole Rusty' - 'SOLD'
1988 S-10 small cab/longbed HT3.4L Crate Engine
1970 Nova 250 I-6, factory 3 sp floor shifter.
1968 Chevelle 'Nomad' Wagon 250 I-6 w/ 3 on da' tree.
04-28-2011, 06:58 PM #7
Extang was the first company to come out with a cover that had a frame system that clamped on so you didn't have to drill holes in the bed of your truck. Now everybody makes 'em.
04-29-2011, 02:22 PM #8
- Join Date
- Dec 2010
great thanks guys this is great info. much appreciated.
05-01-2011, 11:22 AM #9
I have the trifecta hard cover and really like it. I was debating on going with the soft one but to keep stuff more secure went with the hard one. The reason I like the trifecta is it folds in three sections and can easily be removed for full use of the bed.
By Als09Sierra in forum The Coffee Shop ~ Chit ChatReplies: 3Last: 11-15-2010, 12:25 PM
By deepstuff in forum Chevy Truck AccessoriesReplies: 1Last: 05-22-2010, 01:41 PM
By Ttomes in forum General ClassifiedsReplies: 8Last: 04-05-2009, 10:01 PM
By ChevyLover in forum Chevy Silverado Forum (GMC Sierra)Replies: 14Last: 01-16-2009, 09:29 PM
By anthonyl9 in forum Chevy Truck AccessoriesReplies: 4Last: 07-27-2008, 10:15 PM
Tags for this Thread