Results 1 to 1 of 1
Thread: Replaced Hub Bearing
04-29-2011, 10:19 PM #1
Replaced Hub Bearing
I replaced my hub bearing today on my `04 Silverado. The old bearing had 125,000+ miles on it. The job was not so bad.
The hardest part was getting the old one out. I sprayed lots of PB Blaster around it, and beat on it with a hammer. After a few minutes it popped right out. There was a lot of rust in the knuckle bore. Cleaned it out with emory paper and a wire wheel brush on a drill and then lightly greased the bore and surfaces.
The truck rides and steers a lot better now.
2004 Chevrolet Silverado 1500; 4x4; Ext. Cab; 5.3L FI
By tmahan319 in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 12-02-2010, 06:05 PM
By Al Stefanelli in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 03-05-2010, 10:18 PM
By Peckens in forum GM PowertrainReplies: 4Last Post: 09-28-2009, 11:08 AM
By jbeall in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 6Last Post: 02-25-2009, 09:51 PM
By memphisrep in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 1Last Post: 11-21-2008, 05:58 PM