Results 1 to 4 of 4
06-03-2011, 07:18 PM #1
automatic to manual transmission swap?
im looking to see if anyone has done this with there truck and what all had to be done to accomplish this aand how much it roughly cost to do...2000 single cab short bed 1500 w/ 6.0 vortec maxx swap from a 2006 2500, custom intake, slotted brakes, shorty headers, 8mm wires, electric fan, strait piped, 4.5 inch lift, asp pulleys, true dual through body exhaust, built trans w/ shift kit, custom tune by efi alchemy...320rwhp
06-04-2011, 01:51 AM #2
- Join Date
- Sep 2010
- Far West, Oregon USA,
- Blog Entries
I can't tell you what it will cost because geographic location has a profound affect on the price of used parts, but I can tell you a few things you'll run into. If you don't get all your parts from one donor truck & choose to modify some of your own, you'll have to get the driveshaft cut, you'll need a new ds yoke to match the trans tailshaft, you'll have to relocate the rear trans mount crossmember in the frame, (I'd pass on buying a used clutch & pressure plate from a salvage yard. Buy a new Centerforce c & pp unit & you'll be miles ahead), A used wrecking yard flywheel is ok as long as it's not burnt or heat checked or cracked, & the biggest PIA imo is hanging a new pedal cluster. One thing that's often forgotten is you'll need to install a pilot bearing in the rear of the crank for the manual trans input shaft. If you can get all your stuff from one donor truck, you'll be ahead of the game, rather than trying to use & modify some of your stuff. Additionally you'll probably need a few interior pieces like the interior console due to the shifter difference.1988 Chevy C-3500 2wd (no pic)
350 c.i. 5.7 L Stock Block, 4 Bolt Mains
L-31 Vortec Heads, Edelbrock Cam & Intake,
Holley 650, Flowtech Headers, Magnaflow exh.
Jet Trans 700R4, B&M Ratchet, 4:10 gears,
3" susp. lift kit "shadetree"
No rev limiter, No speed limiter lol
06-04-2011, 05:50 PM #3
06-05-2011, 05:57 AM #4
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
What motor do you have?? IF it is the 5.3L you will need to find one from a 4.8L or 6.0L which either are quite rare. And you will need the entire wiring harness. As stephan said it makes a big difference where you live but figure min of $3K.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
By JRD761 in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 01-15-2011, 07:10 PM
By lakelanierboater in forum GM PowertrainReplies: 2Last Post: 11-19-2010, 06:40 PM
By darknox in forum North America - Southeast USAReplies: 0Last Post: 02-01-2010, 10:58 AM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 0Last Post: 06-08-2007, 11:53 AM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 0Last Post: 06-08-2007, 09:20 AM
Tags for this Thread