Results 1 to 3 of 3
06-27-2011, 12:16 PM #1
- Join Date
- Jun 2011
2009 Tahoe transmission vibration
I installed an aftermarket trans cooler on my 09 Tahoe this weekend. 5.3, 6-speed trans. The cooler is a Derale plate/fin. After completing the install and checking for leaks, I took it on a quick 3-4 mile test drive and everything seemed to run smoothly. I did not add any fluid at this time (probably should have). Later that evening, we went out on a longer drive and I started to notice a vibration or fluctuation that felt almost like an engine misfire, but I have to assume it's related to the transmission (too odd a coincidence otherwise). It only does it under normal acceleration, if I accelerated hard, I didn't feel it any longer. but under normal acceleration, it shifts at the expected points, but after each shift, it shudders or vibrates, and I can see the tach needle jumping up an down 100-200 rpm's. I took it home and checked the fluid level hot and it was reading low, which is to be expected since the cooler and additional lines would add capacity to the system. I added a quart of fluid (seemed like a lot) to get it to the appropriate "hot" level. However, the problem persists. At this point it was late so i gave up.
Are these symptoms something that could be caused by a fluid issue? Could it be something as simple as a hose kink, restricting fluid flow back to the trans and causing low fluid like behavior? Could the cooler be restricting proper fluid flow? This evening I'm going to check for hose links and if I don't find that I'm going to bypass the cooler altogether and see if the problem goes away.
06-27-2011, 12:38 PM #2
Welcome to the club. Did you have to add a quart or a pint of trans fluid.:cool:
2005 Chevy Silverado Z71 Crew Cab
6" Skyjacker lift w/Edlebrock dual front remote resoviour shocks, single rear remote. Rancho skid-plate.
17" x 9" M/T Classic Lock Wheels, 35" BFG A/T or M/T tires
4.10 PercisionGears w/factory locker, T/A Performance rear-end cover
Banks CAI intake, ported throttlebody, JBA coated headers, over-sized Magnaflow cats, Magnaflow cat back exhaust, Diablo tuned
B&M aluminum deep transmission pan
Warn brush guard w/Warn 9.5 XP winch, PIAA bulbs, Line-X bedliner, AWS Black tool chest, Extang tonneau cover
Weather Tech floor mats
Cover-Craft seat covers
Dash mat cover
Formula One window tint
One black Lab in rear seat.
06-27-2011, 12:42 PM #3
- Join Date
- Jun 2011
Started with a pint, and when it still read low, I kept adding till I had added a quart. At that point it was reading in the hot crosshatch, with the engine running and trans temp in the 150 range.
By cbdbcbdb in forum GM Powertrain TechReplies: 33Last Post: 03-15-2013, 08:22 PM
By mike042 in forum General Chevy & GM TechReplies: 0Last Post: 02-11-2011, 12:50 PM
By mayers2007 in forum Chevy Silverado Forum (GMC Sierra)Replies: 6Last Post: 12-04-2010, 12:41 AM
By 04tbzr in forum GM Powertrain TechReplies: 0Last Post: 11-23-2010, 07:43 PM
By sublimeveryday in forum GM Powertrain TechReplies: 0Last Post: 01-20-2010, 11:06 PM
Tags for this Thread